1.
sprue-runner-gate area ratio
直浇道横浇道内浇道面积之比
2.
There easily exists shrinkage porosity due to superheat of ingate root in large plain parts investment casting.
大平面铸件常在内浇道根部出现过热,在该处产生缩松缺陷。
3.
Design methods of two representative runner- the fan gate and tapperd runner, were analyzed.
分析了两种典型的横浇道——扇型浇道和切线型浇道的设计方法。
4.
"The Base vault, roadway surface and vault are concreted with concrete pumps and placing Booms with a range of up to 38 m."
用置于隧道内的混凝土泵和布料机对拱形基底、路面板和拱穹浇注混凝土,作用距离可达38米。
5.
Application of Hollow Ceramic Pipe on the Sprue on EPC
陶瓷空心管在消失模直浇道上的应用
6.
Analysis on Lining Crack of Cast-in-place Concrete in Channel and Its Prevention and Cure;
渠道现浇混凝土衬砌裂缝分析与防治
7.
"After each 10 m long Base part-section is concreted, the TVM 18 is relocated, after each roadway surface concreting cycle, the pipe Bridge is moved."
"每浇注10米基底,就移动TVM18, 浇注完一块路面板后,移动管道桥。"
8.
Double Layer Casting Process for M224 Type Internal Grinder Bed
M224内圆磨床床身铸件的双层浇注
9.
Covered in concrete pouring water conservation should be carried out after the12 H.
（1）覆盖浇水养护应在混凝土浇筑完毕后的12H内进行.
10.
On the cast-in-site method rapid construction technology for the road structure of shield highway tunnel
盾构公路隧道道路结构现浇法快速施工技术
11.
drip irrigation; trickle irrigation: The application of water to the soil through small orifices in plastic pipelines.
滴灌:通过塑料管道的小孔对土壤进行浇灌。
12.
Thank you. I usually like a good juicy steak. Will it be long?
谢谢您，我通常喜欢吃浇汁排骨，这道菜时间长吗？
13.
Research on Removing Fusion Line with Hot Runner Multi-gates Sequence Control;
热流道多浇口顺序控制消除熔接痕的研究
14.
The Cause of Crack of Concrete U-shaped Canal and Its Preventives;
现浇砼U型渠道破损裂缝产生的原因及防治
15.
Research of Aluminium-Silica Castable Refractorieson Properties for Kadlo Furnace Flue
卡尔多炉尾部烟道用铝硅质浇注料性能的研究
16.
Preparation of semi-solid feedstock by serpentine pipe pouring
采用蛇形管通道浇注法制备半固态浆料
17.
Construction and Anti-seepage Technology about Pouring Concrete in Channel Lining Project
渠道现浇混凝土防渗衬砌施工技术探讨
18.
Study on Quality Control of Insulation Board Built in the Cast-in-place Concrete Form;
现浇混凝土模板内置保温板施工质量管理研究