1.
APPROACH OF RELATIONSHIP BETWEEN THE CURVATURE INDEX OF SINGLE BUCKLE FOLD AND STRESS EXPONENT OF THE LAYER
单层纵弯褶皱曲率指数与应力指数的关系探讨
2.
Numerical Analysis of Stamping Buckling Cause of Al-Mg-Si Based Alloy Auto Body Sheets;
Al-Mg-Si基合金车身板材的冲压皱曲动因的数值分析
3.
The state of being crisped or curled.
起皱，卷曲起皱或卷曲的状态
4.
The act of crisping or curling.
起皱，卷曲起皱或卷曲的行为
5.
To bend, warp, or crumple, as under pressure or heat.
由于受压或受热而弯曲，起皱
6.
cabbage plant with a compact head of crinkled leaves.
一种甘蓝，其头紧密，具褶皱和卷曲的叶。
7.
Research on impact of parameters to inner-wrinkling in surface drawing
曲面类零件拉深内皱的影响参数研究
8.
Although warped by compaction, there is only stight folding of the sandstone lenses.
虽然由于压实作用而弯曲，但砂岩体褶皱很轻微。
9.
Exaggerated sections distort the shapes of folds as well as bed thickness.
比例放大的剖面歪曲褶皱的形态和岩层厚度。
10.
Research on relativity between fabric's bending performance and its wrinkle recovery angle
棉织物弯曲性能与折皱回复角的关系研究
11.
The rock foundation bent under the horizontal compressive stress. It is called fold. The regional or local stress direction can be analyzed according to the fold structure.
岩层受到水平挤压应力，发生弯曲称作褶皱。通常依据褶皱构造可分析区域或局部应力方向。
12.
When the layers in the shear flow become wrinkled the motion grows complicated, especially when the wrinkles roll up into whirls.
当剪流中流体层开始起皱，尤其是皱褶卷曲成旋涡时，运动就复杂化了。
13.
The imitation wool "wrinkle resistant tie," shrunk by the water, was thin and twisted like an old man's pigtail in Manchu times.
那根充羊毛的“不皱领带”，给水洗得缩了，瘦小蜷曲，像前清老人的辫子。
14.
Numerical Simulation of Wrinkling Onset during the NC Bending Process of Thin-walled Tube;
薄壁管数控弯曲成形过程失稳起皱的数值模拟研究
15.
Research on Wrinkling and Parameter Optimization of Strip Metal In-Plane Bending under Unequal Compressing;
板带不均匀压下面内弯曲过程失稳起皱与参数优化的研究
16.
Research on Wrinkling and Forming Limit of NC Bending Process of Thin-Walled Tube;
薄壁管数控弯曲成形过程失稳起皱及成形极限的研究
17.
Research on Internal Wrinkling and Forming Limit of Strip Metal In-plane Bending under Unequal Compressing;
板带不均匀压下面内弯曲成形过程内缘起皱与成形极限的研究
18.
Look at these two folds. One is convex upward with older rock of Ordovician limestone toward the center of curvature.
请看那两个褶皱，其中一个褶曲是向上凸起，较老的奥陶系石灰岩位于弯曲的中心，