1.
General technical requirement of oil film bearing for rolling mill
GB/T13345-1992轧机油膜轴承通用技术条件
2.
Analysis and research of the breaking of the thick plate rolling mill oil taper sleeve
特厚板轧机油膜轴承锥套断裂原因分析与研究
3.
Advanced Technique Applied in The Lubrication System of Oil Film Bearing at Stechel Mill in Anyang Iron and Steel Group Co.
先进技术在炉卷轧机油膜轴承润滑系统的应用
4.
Development of the Loaded State of Oil Film of Wire Stock High-speed Rolling Mill and Simulation Test System;
线材高速轧机油膜轴承承载状态与仿真测试系统开发
5.
Theoretical and Experimental Studies on Contact Damage of Elastic Force Joint Sleeve of Oil Film Bearing in Rolling Mill;
轧机油膜轴承弹性结合锥套接触损伤的理论与实验研究
6.
Application of Filmatic Bearing Oil on High-speed Rod-rolling Mill
油膜轴承油在高速线材轧机上的应用
7.
Influence of misaligned journal bearings on the start-up process of tandem cold rolling mills
油膜轴承倾斜承载对冷连轧机启动的影响
8.
Study on Oil Film-Roller Combination Bearing of φ200 Cantilever Finishing Mill;
φ200悬臂式精轧机油膜—滚子组合轴承开发研究
9.
Application of Oil-air Lubrication Technology in Work Roll Bearings of Cold Rolling Mill
轧机工作辊轴承油气润滑技术应用分析
10.
This bearing limit rotational speed is low, (therefore mainly applies on the mill calls rolling mill bearing).
该轴承极限转速较低，主要应用于轧钢机上（故称轧机轴承）。
11.
Description: the product we showed is SENDZIMIR Rolling Mills Bearing.
我们展示的是高速线材轧机轴承，即森吉米尔轧机轴承。
12.
The Design and Application of 550mm Tri-roller Rolling Element Bearing Close-top Housing Rolling Mill
Ф550中轧三辊闭口式滚动轴承轧机的设计与应用
13.
Analysis of Lublication and Failure for Thrust Bearing in Cold Mill Main Motor
冷轧主电机止推轴承润滑与故障分析
14.
end shield bearing
机油滤清器内盖头轴承
15.
Researches on the Oil Whip Nonlinear Characteristics of the Rotor-Bearing System
汽轮机转子—轴承系统油膜振荡的非线性特性研究
16.
Control Strategy Analysis and Application of Improvement after the Film Bearing for Mills of Centrifugal Caster
一种改进的油膜轴承离心浇铸机及其控制策略分析与应用
17.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
18.
Design and Remaking of Temperature Control System for Oil Mist Lubrication of Work and Backup Roll Bridle Roll Bearings Box for Foil Mill
箔材轧机工作辊、支撑辊、张紧辊轴承箱油雾润滑温度控制系统的设计改造