1.
Relation of the Property of a Low Viscosity Epoxy Resin Casting Matrix to Its Degree of Cure
低粘度环氧树脂浇铸体性能与固化度的关系
2.
A review of the influential factors of the curing degree of light curing composite resin
光固化复合树脂固化程度的影响因素
3.
The Variation of MBER Stabilized Soil Strength and Development of a New Liquid Soil Stabilizer
MBER固化土强度变化及新型液态固化剂开发
4.
Experimental studies of strength characteristics and solidified mechanism for solidified aeolian sandy soil
固化风沙土强度特性及固化机制试验研究
5.
Research on Over-cured Depth in Stereolithography Process
光固化快速成形工艺中过固化深度的研究
6.
Influence of Curing Temperature on Performance of Epoxy Thermosets
固化温度对环氧树脂固化物性能的影响
7.
The influnce of temperature and curing light units on the microhardness of composite resin
不同温度及不同光固化灯对光固化复合树脂硬度的影响
8.
The rate of curing and consequently the rate of heat generation increase with the temperature.
固化速度，因而还有放热速度，都随温度而增加。
9.
Comparison of the Shear Bond Strength of Light-cured and Chemically-cured Resin Adhesive
光固化和化学固化树脂粘接剂剪切强度的对比研究
10.
When curing temperature below glassy temperature of adhesive coating, bonding strength is reduce with curing extent increase.
固化温度低于胶层的玻璃化温度时，粘接强度随着固化程度的提高而降低。
11.
testing methods for viscosity of epoxide resins and hardners
环氧树脂和固化剂粘度的测定
12.
Again, if there is excessive relative sliding the fluid will become too hot to solidify.
液体温度太高以致也不能固化。
13.
Typical cure temperatures range from 125 to 175℃.
典型的固化温度范围从125～175℃。
14.
Determination of Total Acidity of solid Catalyst by Pyridine-Thermobalance Method
吡啶－热天平法测定催化剂固体总酸度
15.
THE MEASUREMENT OF SURFACE ACIDITY OF SOLID ACID CATALYST BY GAS CHROMATOGRAPHY
气相色谱法测固体酸催化剂表面酸度
16.
The Experimental Study on Unconfined Compressive Strength of Soil Stabilizer;
土壤固化剂无侧限抗压强度试验研究
17.
The Multi-Objective Programming Model on the Disposition Density Optimization of Stationary Traffic Detector
固定型交通检测器配置密度优化模型
18.
Research on Solid-state Infiltrated B_4C for TC4 at Different Temperatures
TC4在不同温度下固态渗碳化硼研究