1.
Design and Construction to Sedimentation of On-line Pipeline withElbows
带弯头弯管段不停输沉降的设计与施工
2.
Thermal recovery numerical analysis on stresses of bended pipe in horizontal well of complex geologic structures
复杂地质构造对热采水平井弯管段套管应力影响的数值分析
3.
A length of pipe with a sharp bend in it.
（管子的）弯曲处一段有弯曲的管道
4.
three-diameter ells with tangents
带切线直管段的三倍直径弯头
5.
Residual Collapsing Strength Analysis of Bending Part Casing in Medium/Short Radius Horizontal Wells
中短半径水平井弯曲段套管剩余抗挤强度分析
6.
There is a sharp bend in the road here.
这段路上有一处急转弯。
7.
The key factors affecting the stagnation point position of L-type pipeline section are the setting position of bellows type expansion joint and the bend angle degree.
影响水平转角管段驻点位置的主要因素为波纹管补偿器设置位置、弯头角度。
8.
A pipe - bending apparatus.
弯管器一种用来扳弯管子的器械
9.
Technical standard for elbows and returns in petrochemical tubular heater
石油化工管式炉急弯弯管技术标准
10.
Reserch on the Bending Techniques of Heating Bending the UOE Pipe Made of Controlled and Rolled Steel;
控轧钢UOE管热煨弯管弯制工艺研究
11.
elbow ,tin, for tubes or pipes
冶锡弯管,用于大小管
12.
elbow ,zinc, for tubes or pipes
锌弯管,用于大小管
13.
"and by his side was working Ezer, the son of Jeshua, the ruler of Mizpah, making good another part opposite the way up to the store of arms at the turning of the wall."
其次是管理米斯巴，耶书亚的儿子以谢修造一段，对着武库的上坡，城墙转弯之处。
14.
Next to him Ezer the son of Jeshua, the official of Mizpah, repaired another section in front of the ascent of the armory at the Angle.
尼3:19其次是管理米斯巴、书亚的儿子以谢修造一段、著武库的上坡、墙转弯之处。
15.
Design for tube bending device of W67-100/3200 bending press
W67Y-100/3200型折弯压力机弯管装置的设计
16.
The induction elbow needs repairing.
吸入弯管需要修理。
17.
Hydraulic Pipe Bender
液压弯管机（俗名喉积）
18.
Copper tube joints-Bends with an angle of 180 degrees
GB/T11618.4-1989铜管接头180°弯头