1.
Intelligent control system for angle of dispenser in ten-thousand-ton multidirectional die forging hydraulic press
1万t多向模锻水压机分配器转角智能控制系统
2.
Modeling and simulating of main distributor's hydraulic servomotor for 300MN die forging hydraulic press
300MN模锻水压机主分配器的接力器建模与仿真
3.
Study on Interior Flow Field of Main Dispenser in the Hydraulic Press;
水压机主分配器内部流场的分析与研究
4.
Die Casting on Cable TV Alloter With CAD
有线分配器压铸模具计算机辅助设计制造
5.
Transformer Flashy Flow Analysis and PC Protect Allocation and Application Study
变压器涌流分析及微机保护配置与应用研究
6.
The Coordination Mechanism of Cascaded SPDs in Low Voltage Distribution Systems
低压配电系统中浪涌保护器配合机理
7.
Feasibility Analysis of Differential Valve Applied to Accident Distributing Valves of Large Hydropower Turbine Control Equipment
大型水电站水轮机控制设备事故配压阀采用差装阀的可行性分析
8.
Configuration and Principle Analysis of Microcomputer Protection for Classified High-voltage Controllable Shunt Reactor
分级式高压可控并联电抗器微机保护配置及原理分析
9.
water-ballast roller
水镇重压路机，充水镇压器
10.
Simulation & Analysis of Turbocharger Matching with Marine Engine by Software;
排气涡轮增压器与船用柴油机的匹配模拟计算分析
11.
Configuration and Setting Analysis About G-T Protections Related with Power Grid
并网发电机变压器组涉网保护的配置原理与整定分析
12.
processor storage relocatio
处理机存储器再分配
13.
matching of turbo-blower and engine
涡轮增压器与发动机的匹配
14.
There are no unmounted compressed drives on your computer.
计算机已经把压缩驱动器全部装配上。
15.
THE MATCHING EXPERIMENT ON VEHICL DI ENGINE AND TURBOCHARGER;
车用柴油机与增压器的匹配试验研究
16.
Investigation of Deutz 1015 Diesel Engine's Turbocharger Used in Plateau
道依茨1015柴油机增压器高原匹配研究
17.
Measurement for Tank Liguid Level of Water Separator and Modification for Hydrodynamic Kinetic Pressure in Ultra-supercritical Boiler
超超临界机组汽水分离器水箱液位测量和流体动压修正
18.
Research on the Calibration between Turbochargers and High Pressure Common Rail Diesel Engine
涡轮增压器与高压共轨柴油机的匹配研究