1.
Out-of-Plane Bending Moment Analysis of the Plastic Limit for the Welded Piping Tee Containing Bottom Thinning Defects
底部减薄焊制三通的塑性极限面外弯矩分析
2.
Non-linear analysis on cast tubular T-joints loaded by out-plane bending
平面外弯矩作用下的T形铸钢节点承载力非线性分析
3.
Moment Redistribution in Prestressed Continuous Steel-concrete Composite Beams with External Tendons;
体外预应力钢—混凝土连续组合梁的弯矩调幅
4.
Theoretical and Experimental Study of Secondary Moment on Concrete Frame Beams with External Pre-stressed Tendons;
体外预应力框架梁次弯矩的理论与实验研究
5.
Buckling Coefficient of Steel and Concrete Composite Beams with External Tendons Under Negative Bending
体外预应力组合梁负弯矩下的稳定系数
6.
Ultimate negative bending-moment capacity of outer-plated steel-concrete continuous composite beams
外包钢-混凝土连续组合梁的负弯矩极限承载力(英文)
7.
The beams are designed with respect to the bending moment.
梁是按照弯矩设计的。
8.
On the influence of the bending moment waveform disturbance on the pure bending beam flexion
弯矩波形扰动对纯弯梁弯扭屈曲的影响
9.
The Calculatiou of critical load by torsion angle-bending moment matix;
用转角弯矩矩阵确定压杆的临界荷载
10.
Each such beam is subjected to the external loads that normally act upon it, together with the two redundant moments at its ends.
每一根这样的梁承受垂直作用于其上的外荷，以及两端的两赘余弯矩。
11.
The Influence of Cold-Formed Effect to Stress Capacity Performance of Cold-Formed Rectangular Hollow Section Beams;
冷弯效应对冷弯矩形钢管梁受力性能的影响
12.
COMPARATIVE STUDY ON BENDING STRENGTHENING METHOD OF NEGATIVE MOMENT AREA AT BEAM END IN RC FRAME
梁端负弯矩区受弯性能加固方法对比试验研究
13.
Research on the Curves Versus Moment Hysteretic Behavior of Thin-walled Cold-formed Steel Beams
冷弯薄壁型钢梁的弯矩-曲率滞回性能试验研究
14.
Calculation for Cracking Moment of SRC Flexural Member
型钢混凝土受弯构件开裂弯矩的计算初探
15.
Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment
面内弯矩下双弯头组合管件的极限载荷研究
16.
Bending moments produced by lift generally have only a small effect on the resultant bending moment.
一般由升力所产生的弯矩对最终的弯矩只有很小的影响。
17.
Torque and Bending Moment in a Shaft with Combined Deformation Measured by Resistance Strain Gauge Method
电阻应变计法测量组合变形轴的扭矩和弯矩
18.
ANALYSIS OF COMPOSITE BENDING MOMENT DIRGRAMS UNDER BENDING AND BENDING DEFORMATON FOR ROUND SHAFT;
关于圆轴含有弯弯组合的合成弯矩图形状的讨论