1.
Effects of such parameters as system pressure, sub-cooling, and pressure loss on flow excursion characteristics and transport capability of heat load are also delivered.
讨论了系统压力、欠热度、阻力等参数对运行稳定性及输热能力限的影响。
2.
Research of Ultimate Longitudinal Capacity of LNG Carrier;
LNG运输船总纵极限承载能力研究
3.
Monitoring and testing method for energy saving of heat transmission and distribution system
GB/T15910-1995热力输送系统节能监测方法
4.
Study on Heat Capacity of Transmission Lines Being Operated;
运行条件下输电线路热载荷能力研究
5.
Model of Air Source Heat Pump(ASHP) under Frosting Conditions Based on Finite-time Thermodynamics
基于有限时间热力学结霜工况热泵性能分析
6.
THERMAL PERFORMANCE STUDY OF FLAT HEAT PIPE AT CAPILLARY LIMIT
平板热管在毛细极限下的传热能力研究
7.
Thermodynamics Evaluation and Analysis for Oil-Gas Gathering and Transferring Energy System
油气集输能量系统的热力学评价与分析
8.
Experimental Investigation on Thermodynamical Performance of 330MW Turbine Units for Zhongning Power Ltd. Company;
中宁发电有限公司330MW汽轮机热力性能试验研究
9.
FINITE TIME THERMODYNAMIC CHARACTERISTIES OF A REGENERATED BRAYTON REFRIGERATION CYCLE
一类回热式布雷顿制冷循环的有限时间热力学性能
10.
The Limit Confirming and Hydraulic/Thermodynamic Calculation Method Research for Oil-gas-water Mixing Transportation Safe in Pipeline during Oil Producing with Supper High Water Cut;
特高含水期油气水管道安全混输界限确定及水力热力计算方法研究
11.
Analysis and Solution on Transfer Capability Decrease of Local Power Grids Caused by Sensitivity of Protection
受保护灵敏性影响限制局部电网输电能力问题分析及解决方案
12.
Study on Temperature Field of the Transfer Roller in Hot Strip Mill by FEA;
热连轧输送辊道温度场的有限元分析
13.
Finite-Time Thermodynamic Performance Characteristics of Isentropic Closed-Regenerated Brayton Heat Pump Cycles
具有等熵压缩、膨胀过程的回热式布雷顿热泵循环有限时间热力学性能
14.
Influence of Post-weld Heat Treatment on Microstructure and Properties of Welded Joints for H_2S Medium Pressure Transmission Pipeline in Repairing
焊后热处理对输送H_2S介质压力管道维修焊接接头组织性能的影响
15.
Thermal Performance Comparison of IGCC System with Transport Gasifier in Different Syngas Clean-up Configurations
输运床气化炉IGCC系统在不同净化方案配置下的热力性能比较
16.
Beneficium competentiae
能力利益，能力限度照顾
17.
Analysis of Thermal Impact Factors on Batching Transportation of Cool and Hot Oil for Long-distance Pipelines
长输管道冷热油交替输送热力影响因素分析
18.
The electric heater should have a heat output rated for the maximum product withdrawal rate requirements, without excessive over-capacity.
电加热器的热输出应该由要求的最大产品提取率来确定，不能有过剩能力。