1.
The Research and Development of Net3DBrowser IGES Postprocessor;
三维图形浏览系统IGES后处理器的研究与实现
2.
Carefully place the CPU into the socket.
最后再将中央处理器置入处理器插座中。
3.
(4)The parameter general post processor is adopted.
(4) 后置处理采用参数化的通用后置处理器；
4.
Drag onto the page, then right-click to make a processor.
拖到绘图页上，然后右击可构成处理器。
5.
The Design of Postprocessor for Five-axis Machine Tool Based on UG/Postbuilder
基于UG/Postbuilder的五轴后置处理器设计
6.
Design of Signal Processing Circuit for SAW Sensor
SAW传感器后端信号处理电路的设计
7.
The Secondary Development to the Post Processor of MasterCAM Based on SINUMERIK802D
基于SINUMERIK802D的MasterCAM后置处理器二次开发
8.
Close the socket by lowering and locking the lever.
当中央处理器已确实装载在处理器插座内后,再将固定扳手扳回。
9.
Notifies the filter when the server has finished processing a request.
服务器完成对请求的处理后通知筛选器。
10.
Error Analysis of Integrated Calculation Amplifier after Idealized Treatment;
集成运算放大器理想化处理后的误差分析
11.
How to Deal with the Feed Rate in Designing the Post Processor System
后置处理器系统设计中进给速度处理方法的研究
12.
Later, following a RUN command, the program is given control of the processor.
接着，在RUN命令之后，处理器就执行该程序了。
13.
Disable write-behind caching for all drives.
禁用所有驱动器的后写式高速缓存处理
14.
Graphics cards take data from the CPU and turn it into pictures.
显卡先从中央处理器读取数据然后再转成画面。
15.
Morphological Changes of Immune Organs After the Treatment of Bleomycin(BLM)
博莱霉素处理后免疫器官的形态学改变
16.
Modularization Development of Pre-and Post-Processors of CAE Software KMAS for Sheet Forming Based on COM;
板材成形CAE软件KMAS前后处理器的COM组件化开发
17.
Research and Development on General Post-Processor of NC Progarmming;
数控加工编程通用后置处理器的研究与开发
18.
Design of Secure Post-Processing Algorithm in True Random Number Generator;
真随机数发生器中的安全后处理算法的设计