1.
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
2.
The Environmental Aspects Analysis For Epoxy Cast Resin Dry-type Transformers
环氧树脂浇注干式变压器环保特性分析
3.
Analysis for thermal ageing problem of resin cast dry-type transformers
树脂浇注干式变压器热老化问题的分析
4.
The new type insulation cylinder used in cast resin transformers
新型结构绝缘筒在浇注型干式变压器中的应用
5.
Development of JLSFW-10 Epoxyn Pouring Type Outdoor Three-phase Combined Transformer
JLSFW-10型环氧树脂浇注式户外三相组合互感器的研制
6.
Dry-type transformers are completely nonflammable, using organic material such as epoxy resin.
干式变压器是完全不燃的,采用如环氧树脂这样的有机材料。
7.
Research on the vacuum casting epoxy insulating materials of high voltage cable accessory
高压电缆附件用真空浇注环氧树脂的研究
8.
epoxy encapsulated transformer
环氧树脂外包之变压器
9.
The current transformer is fully enclosed and busbar structure. The secondary windings and iron core are insulated by epoxy resin. It has a good ability of antipollution and moisture proof.
本型电流互感器为全封闭母线式结构，二次绕组及铁芯均浇注在环氧树脂内，耐污染及潮湿。
10.
The Development of Cast Resin Transformers and Its Requirements to Insulating Materials
浇注变压器的发展及其对绝缘材料的要求
11.
Magnitude Control of Partial Discharge of Epoxy Resin Cast Earth Transformers
环氧浇注接地变压器局部放电量的控制
12.
Study on effect of organic silicon resin on capability of epoxy resin cast
有机硅树脂对环氧树脂浇注体性能的影响
13.
Test method for compressive properties of resin casting body
GB/T2569-1995树脂浇铸体压缩性能试验方法
14.
The zero sequence current transformer is full enclosed type. The secondary windings and iron core are insulated by epoxy resin. The middle hole is used for cable going through.
本型零序电流互感器为全封闭式。二次绕组及铁芯均浇注在聚脂树脂内。中间窗孔供三相电缆穿过。
15.
dry type forced air cooled transformer
干式强制风冷变压器
16.
Dry-type power transformers
GB6450-1986干式电力变压器
17.
Resin Vacuum Cast Process and Its Points for Attention
环氧树脂真空浇注工艺过程及注意事项
18.
Development of casting mould for epoxy resin insulating pull rod
环氧树脂应用于绝缘类零件的浇注模设计