1.
The Evolution Characters of Cross-section in Lower Yellow River and Discussion of the Adjustment Rule;
黄河下游河道横断面形态演变特点及调整规律探讨
2.
Mechanism Research of Water & Sediment Load Variation Impact on Transversal Profile in Jianli River Reach;
监利河段水沙变化及其对该河段河床横断面形态影响机理研究
3.
Variation of channel cross-section morphological parameters and trend of channel shrinkage in Lower Yellow River
黄河下游河道断面形态参数变化与主河槽萎缩趋势分析
4.
The Brittle-Ductile Transition and Impact Fracture Surface Morphology of HDPE/E-TMB Blends and HDPE/Elastomer Blends
HDPE/E-TMB共混物和HDPE/弹性体共混物的脆韧转变和断面形态
5.
Study on Shape Control Principle of Passing through Fault in Fully Mechanized Mining Face
综采过断层工作面形态控制原则研究
6.
Cross-sectional study on growth and development of Chinese Han students;
中国7~18岁汉族学生形态发育的横断面调查
7.
Variation in flow pattem with unit width discharge in the prism canal with trapezia section
梯形断面棱柱体渠道水流流态规律研究
8.
Neuronal Morphology of Facial Nucleus after Facial Nerve Cut Off in Rats
大鼠面神经切断后其神经元形态变化的研究
9.
The hydraulic geometry of Wuding River and its tributaries
无定河及其各支流的断面水力几何形态
10.
The Relationship between Present State of Stressin Part of Active Faults Plane and TheirUnsteady Form in Southwest China
西南部分活动断裂面上现今应力状态与断裂失稳变形的关系
11.
Dual Supporting Points and Specific Attributions in Modern Theory of Ideology--Taken Others and Symptom as Analytical Points;
当代意识形态理论的双重支点及其特质——以他者与征候为理论断面
12.
Dependece of Fracture Surface Morphology on Velocities in Fast Fracture of PMMA;
高速破坏的PMMA断裂表面形态与裂纹速度的相依关系
13.
Investigation on KIC of As-Deposited Ti-6Al-4V Alloy Fabricated by Laser Solid Forming
Ti-6Al-4V合金激光立体成形沉积态的平面应变断裂韧度
14.
Dynamic Fracture of a Cylindrical Interphase Crack under Torsional Load
圆柱形界面相裂纹在扭转载荷作用下的动态断裂
15.
dredged profile monitor
挖泥断面形状监测仪
16.
triangular shaped wire
断面为三角形的钢丝
17.
ultrasonic wave quadrant section diagnostic meter
超声波扇形切面诊断仪
18.
The results show that the fracture surface is characterized by a combination of most intergranular brittle regions and a few cleavage regions, and there are finer precipitations on grainboundaries.
结果表明，成型模裂纹断口形态呈沿晶特征，沿晶面上有细小析出物，为脆性断裂。