1.
Analysis on Optimal Expansion Ratio of Inter-Cooled Regenerative Reheat Cycle
间冷回热再热循环的最佳膨胀比分析
2.
intercooled regenerative cycle gas turbine
中间冷却式回热循环燃气轮机
3.
Design and Calculate on Heat Recovery Type Heat Pipe indirect Evaporative Cooler
热回收型热管式间接蒸发冷却器的设计计算
4.
Heat and Mass Transfer Mechanism and Optimum Design of Heat Recovery of Heat Pipe Type Indirect Evaporative Cooler
热回收型热管式间接蒸发冷却器的传热传质机理及优化设计
5.
FINITE TIME THERMODYNAMIC CHARACTERISTIES OF A REGENERATED BRAYTON REFRIGERATION CYCLE
一类回热式布雷顿制冷循环的有限时间热力学性能
6.
regenerative air cycle
回热式空气制冷循环
7.
Analysis of Heat Transfer Irreversible Regenerated Brayton Refrigerator
传热不可逆回热式布雷顿制冷机分析
8.
The cooling power is 1.93kW when heat and mass recovery is adopted and cycle time is 50min.?
在具有回热回质的条件下，当系统的循环时间为50min时，所得到的制冷量为1.93kW。
9.
Thermodynamic Analysis of CCCP System with Adjustable Regenerative Gas Turbine
可调回热燃气轮机冷热电联产系统热力分析
10.
Research on Regenerative Gas Turbine System with Inlet Air Cooling Powered by Exhaust Heat;
余热制冷进气冷却的回热燃气轮机热力系统的研究
11.
A device for cooling a fluid between successive heating stages.
中间冷却器用于多级热层间冷却流体的装置
12.
There are three types , intermittent fever , remittent fever and relapsing fever.
护士：有三种。即：间歇热、弛张热和回归热。
13.
N: There are three types, intermittent fever, remittent fever and relapsing fever.
护士：有三种。即：间歇热、张热和回归热。
14.
The cold rolled coils are delivered from cold rolling mill into the hot dip galvanizing workshop. The coils leave hot dip galvanizing workshop in form of galvanized coils as final product.
冷轧卷从冷轧车间送至热镀锌车间,成品镀锌卷离开热镀锌车间。
15.
Steel is tempered by heating and then cooling it
钢是经过加热,然后冷却来回火。
16.
Before being passed back to the boiler, the condensate should be preheated.
冷凝液在送回锅炉之前必须进行预热。
17.
Remove the upper radiator hose and coolant recovery hose.
拆卸上散热器软管和冷却剂回收软管。
18.
Optimization and Analysis of Absorption Cooling System Using Waste Gas;
余热回收型吸收式制冷循环优化研究