1.
Optimize the Settling Time Duration the Acceleration to the Constant Velocity Phase in Liner Pendulum by Input Shaping
输入整形技术优化直线摆由加速到稳速运动阶段振荡时间
2.
general epicycloid circular arc spur gear
普通外摆线圆弧直齿轮
3.
Swing Up and Stability Intelligent Control of Linear Single Inverted Pendulum
直线一级倒立摆的起摆及稳摆的智能控制
4.
Swing-Up and Stabilization Research and Design of a Cart-Pendulum Control System;
直线一级倒立摆起摆与稳摆控制研究及控制系统设计
5.
Development of Input Shaping Techniques Experiments Based on Single-liner Pendulum Experimental Platform
直线倒立摆系统的输入整形技术开发
6.
The Optimization Design of Active Disturbance Rejection Control for the Linear Inverted Pendulum
直线单级倒立摆自抗扰控制优化设计
7.
The curve traced by a point on the circumference of a circle that rolls on a straight line.
圆滚线，摆线圆周上任一点在一条直线上滚动时所形成的曲线
8.
The maximum absolute value of a periodic curve measured along its vertical axis.
振幅沿垂直轴摆动的周期性曲线的最大绝对值
9.
A Two-degree-of-freedom Control with Inverse Model on Single-inverted Pendulum;
一级直线倒立摆的逆模型2自由度控制
10.
Modeling of Linear Spring-Connected Double Inverted Pendulum System and Simulating of Free Motion
直线柔性连接两级倒立摆建模与自由运动仿真
11.
Research on Selective Double Closed-loop Fuzzy Control System of Two-inverted Pendulum
直线双倒立摆的双闭环选择型模糊控制系统
12.
The Parametric Design of Cycloid-gear based on Direct Data Transfer
基于数据直接传递的摆线轮参数化设计
13.
Optimal Control of a Linear Two-Inverted Pendulum
基于LQR的一阶直线双倒立摆最优控制系统研究
14.
segmental motion
摆动[膜脂肪分子头部一端固定，另一端沿与膜法线垂直方向作钟摆运动]
15.
Cam profile curve design of cylindrical cam combined mechanism with straight moving -oscillating moving follower
直动-摆动从动件圆柱凸轮组合机构的凸轮廓线设计
16.
Fuzzy Control Study and Implementation of Uniform-Velocity Walking of Linear 1-Stage Inverted Pendulum
一级直线倒立摆匀速行走的模糊控制研究与实现
17.
Take the K8 aircraft as an example, motions of the strut under both the straight and non-straight taxiing are simulated as well as the directional adjusting procedure of the airframe.
以K8飞机为例，考察了非直线滑跑模型与传统的直线滑跑模型的摆振特点及飞机的滑跑稳定性。
18.
A curve traced by a point on or connected with a circle as the circle rolls along a fixed straight line.
旋转线，次摆线圆在固定直线上滚动时，圆上一点或与圆相连的一点的弧形轨迹