1.
The Analyzing of the Spring with Rectangular Section in the Pruning Machine s Transmission Equipment;
整枝机传动机构中矩形截面弹簧的研究
2.
(usually plural) one of the springs holding up the mattress of a bed.
许多弹簧支撑的床面。
3.
A spring lock, as for a door, that is opened from the outside by a key.
弹簧锁从外面用钥匙打开的弹簧锁，用于门上的
4.
"The upper end rests against a flat washer, or spring retainer, which is attached to the valve stem by a retainer lock (also called a keeper)."
上端抵在弹簧座上,在弹簧座的下面用栓销(或叫做定位销)加以定位。
5.
a coiled bedspring in a cloth-covered frame.
在布覆盖下的框架里的弹簧床面。
6.
On the Design of Control System of STM-750 Digital Spring Coil Grinding Machine;
STM-750数控弹簧端面磨床控制系统设计
7.
The thread has not been passed through the notch of the bobbin case tension spring.
底线不能进入到梭壳的线张力弹簧下面。
8.
Measurement of surface tension coefficient using Jolly spring balance
用约利弹簧秤测液体表面张力系数的研究
9.
It is of built-in type, single seal face, single spring and rubber-bellows mechanical seal.
内装式、单端面、单弹簧、橡胶波纹管机械密封。
10.
Study on Heavy Duty Truck's Taper-leaf Spring
重型载货车少片变截面钢板弹簧的研究
11.
spring bow (drawing instruments)
弹簧圆规（绘图仪）
12.
If valves, springs, or seals are to be inspected/replaced at this time, refer to Valves and Valve Springs later in this section for proper procedures.
如果阀、弹簧或密封要在此时检查/更换，关于适当的程序，请参阅本节后面的阀及阀弹簧。
13.
resembling a spring or the action of a spring.
类似于弹簧或者弹簧的动作。
14.
accumulator spring
蓄压器弹簧缓冲系统弹簧
15.
spring eye bolt
(弹簧的)环端螺栓，弹簧眼螺丝
16.
Replace length cut springs to std. springs. Close blind holes.
将定尺弹簧改成标准弹簧.关闭盲孔.
17.
Interested in selling torsion spring, compression spring.
本公司正在供应拉力弹簧,压缩弹簧等。
18.
supported from above especially in a vehicle having springs attached to the axle from below.
从上面支撑的特别是有弹簧从下面连接到轴上的。