1.
The relationship between the thickness of decarbonic layer of metal spring and the temperature and time heated;
金属弹簧脱碳层厚度与受热温度和时间的关系
2.
When the thermometer becomes warmer the mercuracy expands, the amount of expansion measuring the temperature.
温度计受热后，水银就膨胀。其膨胀量度量出温度。
3.
On-line monitor and diagnosis systems for boilers' heating surface over-temperature
锅炉高温受热面温度超限在线监测和诊断
4.
Estimation of the Making-up Temperature of Geothermy Water and the Thermal Reservoir Temperature in the Guanzhong Basin
关中盆地地下热水接受补给时温度及热储层温度的估算
5.
When water is heated, its temperature grows higher and higher until it boils .
水受热时，其温度越来越高，直到沸腾为止。
6.
This emission of heat is completely independent of temperature and pressure.
这热的散发全然不受温度和压力的影响。
7.
Temperature Distribution of Asymmetrical Heated I-beam Steel
非对称受热条件下工字钢温度分布规律分析
8.
Set the number of degrees that any heated component can exceed its assigned set-point temperature before an over temperature fault occurs.
严格限定所有受热零部件温度高于所设定最高运行温度的度数，以防设备过热而出现故障。
9.
These cables can maintain temperatures up to150° F(65° C) and survive intermittent exposure up to185° F(85° C) with power applied.
该电热带维温达65°，在通电情况下耐受的间断暴露温度达85°。
10.
Sets the number of degrees that any heated component can drop below iits assigned set-point temperature before an under temperature fault occurs.
严格限定受热零部件温度的降低幅度，以防设备因过冷而出现故障。
11.
Research on Heating Density Function & Temperature Field Mathematical Model for Milling Insert with 3D Groove;
三维槽型铣刀片受热密度函数与温度场数学模型的研究
12.
hot junction temperature
热接点温度（热电偶）
13.
dry adiabatic lapse rate
干绝热〔温度〕递减率；干绝热〔温度〕直减率
14.
The dots turn red as they register heat.
温度点变红以标记热度．
15.
Determination of time-temperature limits of plastics after exposure to prolonged action of heat
GB/T7142-1986塑料长期受热作用后的时间-温度极限的测定
16.
The FDV is controlled by a temperature-sensing device located at the exit of the heating section of the system.
FDV受一个设置在设备加热段出口的温度传感器控制。
17.
The rate of TSR in geologic settings is limited by temperature and activation energy.
地质条件下热化学还原反应的速率受温度和活化能的制约。
18.
When tube wall strength can not bear inner steam pressure in the tube, blowout of low-temperature tube occurs.
当管壁强度无法承受管内蒸汽压力时，导致低温过热器管爆裂。