1.
refractory-lined chamber
耐火材料内衬加热室
2.
direct pressure hot-chamber machine
直接加压的热室压铸机
3.
an enclosed chamber in which heat is produced to heat buildings, destroy refuse, smelt or refine ores, etc..
热量被用来加热房间的环绕的小室。
4.
Non-thermal storage electrical room heaters
GB/T15470-1995非储热式室内电加热器
5.
Various kinds of water heating includeing bathroom water heating civilian life and process water heating for industrial purposes.
各种水加热，包括民用盥洗室里的水加热及工业上工艺水的加热。
6.
in-and-out type furnace
分批装出料的室式加热炉
7.
Adopting the platetype heater to evenly distribute to heat over the outer wall of the chamber.
采用平板式加热器，均匀分布在工作室外壁。
8.
High frequency instabilities result in grossly increased convective heat transfer coefficients in the chamber walls.
高频不稳定性使室壁对流传热系数大大增加。
9.
Auxiliary Heat Equipment Design of Engineering on Big or Middle Bathroom of Solar Energy
大中型太阳能浴室工程辅助加热设备设计
10.
Improvement for Room Type of Forging Furnace Door Equipment
室式燃气锻造加热炉炉门口装置的改进
11.
Design and Optimization of the Height of PCR Reactor and the Structure of Micro-heater in PCR Chip
PCR芯片中微腔室高度及加热器结构优化设计
12.
Application of Solar Energy Soil Heating System in Greenhouse
日光温室太阳能地热加温系统应用效果研究
13.
The inhabitants and other internal loads create an up wards flow due to their buoyancy.
居住者和其他室内热荷载加热新风，产生上升的气流。
14.
In an adiabatic system, this heat release serves to increase the chamber temperature.
在一绝热系统中，放出的热量增加了燃烧室的温度。
15.
The Investigation on Heat Transfer Characteristics of the Longitudinal Ripple Heat Shield Channel in Afterburner;
加力燃烧室纵向波纹隔热屏通道换热特性的试验研究
16.
The same control also activates a pump on the domestic water side that circulates water through the heat exchanger, where it is heated by the heat transfer fluid.
相同的控制也会启动在室内水侧的泵，使水穿过热交换器，在热交换器中，水被载热流体加热。
17.
Coking is done in tall and narrow coking chambers, or ovens. The ovens are externally heated by combustion chambers of the same length and height.
炼焦是在又高又窄的碳化室中进行的。碳化室由高度和长度相同的燃烧室从外部加热。
18.
In the second stage, room temperature preforms are reheated, stretched and blow moulded into bottles, in a reheat stretch blow moulding machine.
第二步将室温的瓶坯再加热后，拉吹成为瓶子，是在另一台“再加热，拉吹机”上完成。