1.
Study on the New Ceramic Slurry Manufacture System with the Internal Recycling Mill as Main Equipment;
以内循环高效研磨机为主体设备的陶瓷新法制浆系统及应用研究
2.
The Fundamental Research of High-efficiency and Low-pollution Gas-Turbine Cycle;
高效低污染燃气轮机循环的基础研究
3.
Constructing the Circular,Inherent and High-speed Mechanism of Student Affairs Systematically;
构建循环、内在、高效的学生工作系统机制
4.
Study to Advance Ability Vibration Abasement Crusher of Circulate Burden
提高筛分效率降低破碎机循环负荷的研究
5.
Study on Flow Hydrodynamics, Combustion and Abrasion Properties of CFB Boiler Burning Anthracite;
无烟煤循环流化床内流动、燃烧与磨损的研究
6.
Study on High-Temperature Abrasion Resistant Coatings of Circulating Fluidized Bed Boiler;
循环流化床锅炉用耐高温磨蚀涂层的研究
7.
Research shows that surface coating technology is an economical and effective means to solve this problem.
大量研究表明,表面涂层技术是解决循环流化床锅炉高温磨蚀问题的一种最经济有效的方法。
8.
The Failure Analysis and Improvement of the Mill Balls and the Research of the Method of Raising the Milling Efficiency;
球磨机磨球失效分析与改进及提高磨机生产效率的方法研究
9.
Research on the Wetting-Drying Effect and Micro-Mechanism of Expansive Soil;
膨胀土干湿循环效应与微观机制研究
10.
Research on Technology of Filtration s Application on High Efficiency Comminution by Tumbling Mill;
磨内筛分技术在管磨机高细高产粉磨中的应用研究
11.
Failure Analysis on Corrosion of Inner Piping of High Pressure Circulating Cooler
高压循环气体冷却器内管腐蚀失效分析
12.
Investigation on the Characteristics and Formation Mechanisms of Grinding Force and Energy in High Efficiency Deep Grinding for Advanced Ceramics;
工程陶瓷高效深磨磨削力和磨削能的特征及形成机理研究
13.
Synthesis of High Efficient and Environmental Scale Inhibitor for Circulated Cooling Water;
高效环保型循环冷却水处理剂的开发研制
14.
This mill together with separator can form close-circuit grinding system for grinding clinker into cement products.
本磨机与选粉机组成循环圈流粉磨系统，将熟料粉磨成水泥成品。
15.
Effect of Air-circulating and Condensation Dehumidification inside Greenhouse in South China
南方温室内空气循环式冷凝除湿效果研究
16.
Research on simulation experiment method of piston ring and cylinder friction and wearing;
内燃机活塞环—缸套摩擦磨损实验方法的研究
17.
Load Capacity of Asperities for Piston Ring-Cylinder Liner in Internal Combustion Engine at Running-in Stage
内燃机缸套-活塞环磨合过程中微凸体承载研究
18.
Research into the Failure Mechanism of Circular Mould of Pelletizer and Its Optimal Design;
制粒环模磨损失效机理研究及优化设计