1.
flushmounted pressure transducer
同平面装配压力传感器
2.
Design and application of assembling pressure
阀控式铅酸蓄电池装配压力的设计和应用
3.
WORK NEW GROMMETS INTO PLACE USING FINGER PRESSURE ONLY
仅用手指压力将新套环装配到位
4.
Mechanical Analysis of Pressing Assembly Based on Finite Element Analysis
基于有限元方法的压合装配力学研究
5.
Analysis of Prestressed Subassemblage Concrete Frame on Load-Bearing Capacity;
预压装配式预应力混凝土框架极限承载力分析
6.
Study on the Earth Pressure and Structural Internal Forces of Fabricated Tunnel
装配式管型通道土压力和结构内力分析
7.
Pressuremeter: Check sundries in the pressuremeter assemblies, eliminate all visible sundries, and replace the assemblies.
压力表：检查压力表装配件里的杂物，清除所有可见性杂物，并更换装配件。
8.
Deformable Analysis of the Prestressed Subassemblage Concrete Frame;
预压装配式预应力混凝土框架的变形分析
9.
Experimental studies and calculating method for compression and uplift capacities of fabricated steel foundation
装配式型钢基础抗压抗拔承载力的试验及计算
10.
Mechanical Analysis of Joint Area of Prestressed Subassemblage Concrete Frame;
预压装配式预应力混凝土框架连接区域受力分析
11.
Pseudo-dynamic Test and Analysis of Prestressed Subassemblage Concrete Frame;
预压装配式预应力混凝土框架拟动力试验及分析
12.
Static Elasto-plastic Pushover Analysis to Pre-stressing Concrete Fabricated Frames
预压装配式预应力混凝土框架结构静力弹塑性pushover分析
13.
mounting of propeller by hydraulic jack
螺旋桨液压无键装配
14.
Experimental Study and Analysis of Prestressed Subassemblage Concrete Frame on Moment Modification;
预压装配式预应力混凝土框架弯矩调幅实验研究与理论分析
15.
The Experimental Study and Three-dimension Finite Element Analysis of the Behavior of Subassemblage and Prestressed Frame Joints under Loads;
预压装配式框架节点受力性能试验研究及三维有限元分析
16.
Theory and Method for Design of Pre-stressing Concrete Fabricated Frames;
预应力混凝土预压装配式框架结构设计理论与方法
17.
Analysis of the Behaviour of Subassemblage and Prestressed Concrete Frames under Vertical Loads;
预压装配式预应力混凝土框架竖向荷载作用下的整体性分析
18.
Shear Capacity of Subassemblage and Prestressed Concrete Frame Joints;
预压装配式预应力混凝土框架节点抗剪性能研究