1.
Discussion on the Computational Methods of Eccentricity Magnification Coefficient of Eccentric Compression Reinforced Concrete Members
钢筋混凝土偏压构件偏心矩增大系数计算方法探讨
2.
Analysis of Disturbing Torque in Electrostatic Field Caused by Rotor Radial Disbalance in ESG
静电陀螺转子径向偏心干扰力矩分析
3.
Discussion about"Analysis of Correlation Curves between the Axial Force of Eccentrically Pressed Member with Rectangular Cross Section and the Bending Force Moment;
关于“矩形截面偏心受压构件轴力——弯矩相关曲线分析”的探讨
4.
The limit of dimension eccentric compression under the situation of rectangle asymmetric reinforcement
矩形截面不对称配筋下大小偏心受压的界限
5.
Research on Loading Capacity of Short Column Made of Concrete-Filled Rectangular Steel-Tube under Eccentric Compression
偏心受压矩形钢管混凝土短柱承载力研究
6.
Research on Motion Character of Two-axle Vibrating Screen with Same Mass Moment and Mass Center Deviated Vibrator
质心偏移式等质量矩双轴振动筛运动特性研究
7.
The Influence of Pre-eccentricity of Single-Pier Support on Torsion Re-distribution of Continuous Curved Bridges
支座预偏心对独柱曲线连续梁桥扭矩重分布的影响
8.
moment due to elevator deflection
偏转升降舵产生的力矩
9.
"Torque is calculated by multiplying the push by the crank offset, or the distance of the push from the rotating shaft,"
扭矩以推力与曲柄偏心距或旋转轴心至推力作用点的距离相乘计算。
10.
eccentric sheave
偏心内轮偏心皮带轮
11.
The Test and Theory Study in the In-Plane Stability Capacity of Hot-rolled H-section Columns under Eccentric Load;
热轧H型钢偏心受压构件在弯矩作用平面内极限承载力的理论与试验研究
12.
be biased in favor of a person
对某人有偏心 [偏爱]
13.
Partial Ordering of Generalized Inverse and the Solution of the Equation of Matrix Polynomial Function;
矩阵广义逆偏序与矩阵多项式函数方程解
14.
The distance between the center of an eccentric and its axis.
偏心距偏心圆的中心与圆轴间的距离
15.
The Structure Design of Magnetic Suspension Momentum Wheel with Deflection Angular Momentum;
动量矩可偏置磁悬浮动量轮结构设计
16.
The Spectram of Hamiltonian Operator Matrics Corresponding to Partial Differential Equation
由偏微分方程导出的Hamilton算子矩阵的谱
17.
Analysis of Double Plate Rotation Depolarizer by Mueller Matrix
双光楔旋光退偏器的Mueller矩阵分析
18.
Reason for the Greater Tilting Moment of a 220 t Converter
220t转炉倾动力矩偏大的原因分析