1.
Research on Industry Gathering under Various Angle Veer of Economical Geography;
经济地理学多角度转向背景下的产业集群研究
2.
the VGRS (Variable Gear Ratio Steering) actuator which controls the front-wheel steering angle
控制前轮转向角度的可变齿比转向系统（VGRS）
3.
And method of administration has developed from monotonous to a many-sided way.
管理方法从单一向多角度方向发展；
4.
(especially of aircraft wings) angled rearward from the point of attachment.
（尤指飞机机翼）从连接点向后转变角度。
5.
What is the angular velocity after the ball has made five complete revolutions?
在球转了五整圈之后，角速度是多少？
6.
The research Based on cycloidal automotive steering device of front-wheel steering angle adaptive control function
基于前轮转向角度自适应控制功能的摆线式汽车转向器研究
7.
Parameter programmable: slot number, circle number, rotation degree、hooking degrees and locomotion can all be programmed.
参数可编程：槽数、匝数、转角度数、挂钩度数、转向等可编程。
8.
Philosophy:from an Onlooker to a Participant;
哲学的转向:从旁观到参与——从杜威的角度看
9.
On Modernity of Marxist Philosophy;
从哲学转向的角度看马克思主义哲学的现代性
10.
Study on feedback control of yaw angle rate based on active front steering
基于主动前轮转向横摆角速度反馈控制的研究
11.
steering wheel impulse input test
转向盘转角脉冲试验
12.
Reflection on multi-disciplinary research of higher education:from the disciplinary to the methodological viewpoint;
高等教育多学科研究之反思——从学科性视角到方法论视角的转向
13.
A Corner Extraction Method Based on Multi-spectral Double-directional Detection and Multi-scale Corner-characters Validation
一种利用多光谱双向检测和多尺度角特征验证的角提取方法
14.
Rotate the stage about the axis ?? through a small angle in the direction in which the light is most rapidly restored.
沿着使光最快地复现的方向，使旋转台绕??轴转过一个小角度。
15.
MULTIPLE LINE-VORTEX MODEL OF VORTEX FLOWS AROUND BODY OF REVOLUTION AT HIGH ANGLES OF ATTACK UP TO 60 DEGREES
迎角直到60度旋转体涡流的多重线涡模型
16.
Rotation-based Standardized Algorithm of Multi-angled Single Face;
基于旋转变换的多角度单人脸标准化算法新探
17.
Take the actions of the driver into account (steering angle, brake pressure, accelerator position).?
分析驾驶员操作及意向(转向角度，刹车压力，油门位置等)
18.
In addition to forward and backward rotation, center of rotation and rotation angle in certain procedures can be set up.
除向前和向后旋转以外，旋转中心点和旋转角度在某种程序上可设置。