1.
Study on Immediate Quenching Process of Martensitic Based Spheroidal Graphite Cast Iron Grinding Ball
马氏体基球墨铸铁磨球的余热淬火工艺分析
2.
Research on Heat Treatment Technology of 5CrMnMo Hot Forging Die
5CrMnMo热锻模淬火工艺研究
3.
Development of Scans Induction Hardening Process for Single-Tooth;
单齿连续感应加热淬火工艺技术研究
4.
Successive Induction Heating and Hardening Process Research on Gear Copy Profile
齿轮仿齿形连续感应加热淬火工艺研究
5.
The Quenching Procedure Test of SA387Gr11CL2
SA387Gr11CL2钢淬火工艺试验
6.
Research on Sub-temperature Quenching Process of 30CrMnSiA Steel
30CrMnSiA钢亚温淬火工艺研究
7.
The Annealing Technics and the Ways Using Residual Heat of High-Speed Steel after Forging (Or Rolling);
高速钢锻（轧）后的余热退火工艺及余热利用方法
8.
Subcritical Quenching Technique for 45 Steel May Reduce Quenching Dehiscence Tendency
45钢亚温淬火工艺可减少淬火开裂倾向
9.
The heat treatment technology of carbo- nitriding of steel has the characteristic of lower treatment temperature and direct quenching.
钢的碳氮共渗热处理工艺具有共渗温度低、直接淬火等特点。
10.
Evolution of ultra-fine austenite grains in Nb and Nb-V-Ti microalloyed low carbon steel under cyclic heating-quenching treatment
循环加热-淬火工艺下超细晶奥氏体的晶粒演变特征
11.
A brief introduction to quenching-partitioning-tempering (Q-P-T) process
淬火-碳分配-回火(Q-P-T)工艺浅介
12.
Study of the Obdurability of 20CrMnTi Cutting Picks Treated by Lye Quenching after Hard Soldering
20CrMnTi截齿齿体钎焊余热碱液淬火强韧性研究
13.
Water Quenching and Tempering Technology Research of 1000MPa Ultra-High Strength Dual-Phase Steel;
1000MPa超高强双相钢水淬及回火工艺研究
14.
Process Research on the Isothermal Quenching of Ductile Iron of Austenite and Bainite;
奥氏体贝氏体球铁等温淬火工艺研究
15.
Design of Timed Quenching Process for 42CrMo4 Steel Shaft
42CrMo4钢轴类件控时淬火冷却工艺的设计
16.
Step Iso-Thermal Quenching Process Used to Obtain Heavy Section ADI Casting
用于厚大ADI铸件的分级淬火工艺
17.
Technical of Study Compound of 18Cr2Ni4WA Steel
18Cr2Ni4WA钢复合等温淬火工艺研究
18.
Research of quenching and aging institution for an Al-Zn-Mg alloy sheet
Al-Zn-Mg合金板淬火时效工艺研究