1.
Both the structure of die without punch guidance and protecting jacket are analyzed, and opinions that intensity of blanking small punch should be verified are concluded.
对无凸模导向和保护套的模具结构进行分析,提出冲裁小凸模强度核算应考虑的问题。
2.
Strength and Mode Analysis of Ring-Plate Planetary Indexing Cam Mechanism;
环板式行星分度凸轮机构的强度与模态分析
3.
Research on the knurling connection strength of hollow assembled camshaft
中空组合式凸轮轴滚花连接强度研究
4.
Study on Strengthening Technology of the Bearing Enclose Hot Die Protruding Mould
轴承内外圈热冲模凸模强化技术的研究
5.
Some ways to raise punch andurance are outlined.
概述了提高凸模耐用度的具体途径。
6.
Using precisely graduator of cam,hypo-mood position fixing accurately.
采用精密凸轮分度器，下模定位精确。
7.
The Effect of Virtual Punch Velocity to the Simulation Result of Sheet Metal Forming
虚拟凸模速度对冲压仿真结果的影响
8.
A New Accurately Modeling Method for Complex Globoidal Indexing Cam
复杂弧面分度凸轮精确建模的新方法
9.
die ,for relief printing for stamping
凸版印模感压凸印模
10.
Research on Fractal Method for Contact Strength Calculation of the Concave-Convex Meshing Gear
凹凸啮合齿轮接触强度计算的分形方法研究
11.
Both osteotomy for correction of severe kyphotic in ankylosing spondylitis
双椎体截骨术矫正重度强直性脊柱炎后凸畸形
12.
Study on the Induced Curvature and Strength Design of the Globoidal Cam Mechanism
弧面凸轮机构诱导曲率与强度设计的研究
13.
Building of Unified Precision Analysis Stochastic Model for Cam Indexing Mechanisms
分度凸轮机构精度分析统一随机模型的建立
14.
Effects of Ionic Strength,Temperature and Humic Substances Concentration on the Sorption of Th(Ⅳ) to Attapulgite
离子强度、温度、pH和腐殖酸浓度对Th(Ⅳ)在凹凸棒石上吸附的影响
15.
STRONGLY PREQUASI-INVEX FUNCTIONS AND STRONGLY QUASI-INVEX FUNCTIONS;
强预拟不变凸函数与强拟不变凸函数
16.
Research of TFP Calculation Based on Regression Model with Convex Constraint;
基于凸约束回归模型的全要素生产率测度研究
17.
The Solid Modeling of Disc-type Tool Magazine Based on Cylindrical Index Cam;
基于圆柱分度凸轮圆盘型刀库的实体建模
18.
A kind of Bayes Dynamic Models with Log-concave Density;
一类对数凸密度下的Bayes动态模型及其处理