1.
The effects of five adjusting parameters of valve timing, admission valve clearance, emission valve clearance, rotational speed ,load rate are interacted.
配气相位、进气门间隙、排气门间隙、转速、负荷五个调整参数之间是相互影响的。
2.
"adjusting valve tappet clearances (also called adjusting valve lash), grinding valves and valve seats."
气门维修包括调校气门间隙(也称气门余隙),研磨气门和气门座.
3.
valve-tappet clearance adjuster
气门挺杆间隙调节器
4.
Hydraulic Valve Lash Adjuster (HLA) and Valve Train with HLA
液压气门间隙调节器及有间隙调节器的气门机构的研究
5.
Valve Lash Adjuster
气门间隙调节器又称液压挺杆
6.
Valve Tappet Adjustment For Three And Five--Cylinder Engines
三缸与五缸内燃机气门间隙调整方法
7.
Using Vibration Signal to Diagnose Abnormal State of Engine Valves Clearance;
基于振动分析的气门间隙异常故障诊断
8.
Valve Breakage. Any condition that causes the valve to overheat or to be subjected to heavy pounding (as from excessive tappet clearance or from detonation ) may cause valves to Break.
气门破裂:气门过热或遭受重载(气门杆间隙过大或爆裂)均可造成气门破裂。
9.
Valve sticking. Gum or carbon deposits on the valve stem will cause valve sticking. Excessive valve-stem clearance speeds up valve deposits.
气门沾着:气门杆上的胶质或积炭是造成沾着的原因。气门杆间隙过大会加速气门的积炭。
10.
In the case of a pit drain, ensure an adequate air gap exists between the bottom of the drain line and the bottom of the pit.
在坑内排放时，请确保在排放管线和坑底部之间有适当的气隙存在。
11.
A physical air gap must be maintained between the discharge pipe and the drain or sump.
必须在排放管道和排水沟或污水坑之间配置一个硬件气隙。
12.
Recheck clearance on all valves again after locknut is tightened.
防松螺母拧紧后，再对所有气门的间隙重新检查一次。
13.
Improving the Assembly Process to the Washer for Adjusting the Valve Clearance in Diesel Engine by Measuring Tools
借助量具改进柴油机气门间隙调整垫片装配工艺
14.
Vibration Signal Fusion Technique and Its Study in Valve Clearance Fault Diagnosis of Engine;
车辆发动机气门间隙故障振动信号融合技术研究
15.
Dynamic Simulation and Leakd-down Experiment of Valve Train with Hydraulic Lash Adjuster;
有液压间隙调节器气门机构的动力学模拟及泄沉特性试验研究
16.
piston to head clearance
活塞底和气缸头间隙
17.
stator-to-rotor air gap
定子转子间的空气隙
18.
But like the inlet valve, the exhaust valve needs time to reach the full-open position, It also needs time to reach the full-closed position.
但是像进气门一样，排气门需要时间到达充分打开和关闭的位置。