1.
Design Methods of Tee Branch of Directly Buried Heat-supply pipeline
直埋敷设供热管道三通支管设计方法
2.
Stress Analysis and Force Calculation on Buried Heating Pipeline;
直埋敷设供热管道应力分析与受力计算
3.
Applications of burying and trench laying in heat supply engineering
直埋敷设与地沟敷设在供热工程中的应用研究
4.
Study of Design and Calcuation Method for Directly Buried Heating Pipe;
直埋供热管道设计及计算方法的研究
5.
Foundation of Finite Element Model for Directly Buried Hot Water Heat-supply Pipeline
直埋热水供热管道有限元模型的建立
6.
Stress Analysis and Calculation of Overground and Trench Laying Heat Pipe;
地上和管沟敷设供热管道的受力分析与计算
7.
Application of Preserving Heat and Direct-buried Pipeline for DHC System
区域供冷供热工程中的预制保温管道直埋应用
8.
For laying indoors,in trenchesin ducts and in ground,able tobear heavier pulling force,andfor fixed installation.
敷设在室内、电缆沟、管道、直埋等能承受较大机械外力等固定场合。
9.
The Experimental Study and Analysis of Directly Buried Inner Resistance Heat-preservation Pipeline;
内阻式直埋保温供热管道的实验研究与分析
10.
Analysis of Force and Protection of the Taper Pipe in Directly Buried Heat-Supply Pipeline
直埋供热管道变径处的受力分析与保护
11.
Construction Technique of the Direct-burial Non-compensation Heating Pipelines in Liuqi Road of Lishi City
离石市刘七路直埋式无补偿供热管道施工工艺
12.
There were three basic construction modes during the initial period of Alaska Pipeline design: conventional burial, special burial, and above ground berm or pile bent.
阿拉斯加原油管道设计有传统埋设、特殊埋设和地上敷设。
13.
Design and Application of Construction Equipment for Laying Large-Diameter PE Pipe under Sea Bottom
大口径PE管道海底敷埋施工设备的设计和应用
14.
Method of Laying Pipes and Researches on Construction Technology of Feed Pipe Water Supply Project in the Deep Sea of Nanri Isload,Putian
南日岛深水跨海管道供水工程管道敷设方法
15.
Design of buried depth for vertical ground heat exchangers based on the energy efficiency degree
基于换热能效度的竖直地埋管埋设深度设计
16.
Some problems, which are needed to pay attention to on the construction and design of polyurethane insulation pipe buring laying are presented.
并对聚氨酯保温管直埋敷设的施工和设计提出了一些建议。
17.
Simulation and Emulation of Internal Resistance Heating Direct-Burried Heat-Insulated Pipe;
内阻式供热直埋保温管热工模拟与仿真
18.
The temerature not less than O℃ and recommended bend radius not less than6 times of outer dia.
电缆适用于管道地埋及架空敷设，不能承受机械外力作用。