1.
The Study of Level Set Method for the Flow Filling Process in the Mold of Polymer;
聚合物成型中熔体充填过程的Level Set方法研究
2.
Research on Flowchart Simulation of Filling Process of Plastic Melt in Injection Mould
注塑模塑料熔体填充过程的流程图模拟研究
3.
Experiment Study on Filling Imbalance Phenomenon of Melt Front during Injection Molding Process
注射成型过程熔体前沿充填不平衡现象的试验研究
4.
HEAT BALANCE AND SOLIDIFICATION IN ESR USING HIGH FILL RATIO
大充填比电渣重熔热平衡与凝固研究
5.
Process window analysis, another part of mold flow analysis, examines melt temperature, mold temperature, injection pressure, and fill times.
加工窗口分析、它零件的模流分析，检查熔体温度、具温度、塑压力和充填时间。
6.
The act of inflating or the state of being inflated.
充气充填气体的动作或被充气的状态
7.
Filling Path Optimization of FDM System for Fuse Extrusion
熔丝挤出快速成型系统的填充路径优化
8.
Test and Study on Reducing ESR Power Consumptions by Large Filling Ratio
电渣重熔大充填比降低电耗的试验研究
9.
Filling Path Optimization of Fused Deposition Modeling and Research of FDM Soft System;
熔丝沉积成形填充路径优化及其软件研究
10.
Research on the solution of interfered ring in path planning of offsetting style in plasma deposition manufacturing
等离子熔积成形过程中等距线填充算法研究
11.
pore volume of porous packing
多孔填充剂的孔体积
12.
permeable consolidated gravel pack
可渗透胶结砾石充填体
13.
Discussion about relation between the rate of supporting pit roof and supporting effect of backfilling mass
坑采充填接顶率与充填体承载效果关系探讨
14.
In Vitro Comparison of the Obturation Density by Three Techniques;
三种根管充填技术体外充填密度的对比
15.
There can be some trade off between die temperature, cavity filling time and the temperature of the molten metal.
在压铸模温度、腔充填时间和金属熔化温度之间可能要做某些权衡。
16.
As the plates separate, hot molten mantle material flows up to fill the void.
随着板块的分开，炽热的熔融地幔物质向上流动，以填充空隙。
17.
A small mass of soft material, often folded or rolled, used for padding, stuffing, or packing.
填充物一块软的物体，常叠着或卷着，用于垫料、填充或包装
18.
STUDY ON SEDIMENTATION CHARACTERISTICS AND STRENGTH DISTRIBUTION OF FILL IN DRIFT CUT AND FILL MINING
巷道式充填法回采进路充填体沉积特征及强度分布规律研究