1.
Abrasion tests are universally carried out under atmospheric conditions.
耐磨试验通常在常压条件下进行。
2.
Atmospheric pressure fabrcation of SnO_2 nanowires and its optical propertiy
常压条件下制备SnO_2纳米线及其光学性能研究
3.
Study on Raman Spectrometric Characters of Fluid Inclusions of TongChang Porphyry Copper Deposit, Dexing County of JiangXi Province, Under the Condition of Non-common Temperature and Pressure;
德兴铜厂铜矿非常温常压条件下的流体包裹体拉曼光谱特征及其成矿意义
4.
Non-conditional Logistic Regression Analysis on Influence Factors of Abnormal Blood Pressure
异常血压影响因素非条件Logistic回归分析
5.
Different condition on measure results of rabbit intraocular pressure
不同测量条件对兔正常眼压测量值的影响
6.
Studies on the Processing of Decreasing the Oiliness of Fried Potato Strips under Normal Pressure;
常压油炸条件下降低油炸薯条含油量的工艺研究
7.
Gasificaiton of Different CWS-char and CBLS-char at Ambient Pressure and Elevated Pressure;
不同煤种水煤浆与黑液水煤浆在常压和加压条件下的气化特性
8.
Visible Absorption Spectra Study of Four Kinds of Carotenoids under Normal and High Pressure
常压和高压条件下四种类胡萝卜素可见吸收光谱的研究
9.
The Raman Spectra Study of Five Kinds of Carotenoids under Normal and High Pressure
常压和高压条件下五种类胡萝卜素拉曼光谱的研究
10.
Pressure-triggering and/ or flow-triggering are the most frequent modes we have used as triggering variables.
近代呼吸器常使用的驱动条件通常是压力驱动或者是气流驱动。
11.
The Unsteady Mechanism and the Role of Tip Clearance Flow in Distortion Induced Instability in an Axial Compressor;
畸变条件下轴流压气机叶顶间隙流对流动失稳影响的非定常机制
12.
EXPERIMENTAL INVESTIGATION ON MECHANICAL PROPERTIES OF COARSE SANDSTONE AFTER HIGH TEMPERATURE UNDER CONVENTIONAL TRIAXIAL COMPRESSION
高温后粗砂岩常规三轴压缩条件下力学特性试验研究
13.
An experimental study of the characteristics of diorite melt composition under different degree of melting
高温高压条件下闪长岩部分熔融产物的反常现象
14.
The temperature and pressure condition each other.
温度和压力互为条件。
15.
This is the maximum continuous sinusoidal rms voltage, which maybe applied at any temperature upto the maximum operating temperature of the device.
在规定的环境条件下，保证压敏电阻器正常工作所允许连续施加的最大交流电压值。
16.
a formal requirement that is usually ignored.
通常被忽略的表面条件
17.
General specification of hydraulic pumps and motors for ship
GB/T13853-1992船用液压泵液压马达技术条件
18.
Technical specification of shop fabrication for pressure parts of chemical furnace
化学工业炉受压元件制造技术条件