说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 正常磨损
1.
fair water and tear gradual deterioration
正常磨损和自然损耗
2.
Apart from fair wear and tear, the car is in excellent condition.
这辆车除了正常磨损外,一切完好。
3.
Study on the Mechanism of Tire Abnormal Wear and Life Prediction;
轿车轮胎非正常磨损机理及使用寿命预测研究
4.
Service shall include the labor and parts required to repair Product which has become defective through normal wear and usage. This does not include consumable and their installation.
维修包括维修正常磨损及使用损坏的产品所需要的劳务以及配件,但不包括消耗品及它们的安装。
5.
Failure due to normal deterioration or mechanical wear, the probability of which increases with usage.
由于正常损耗或机械磨损而产生的失效,其概率随使用时间而增加。
6.
Inspect timing chain for wear.
检视正时链有无磨损。
7.
Check for scores, nicks or burrs on the rack piston finished surfacSlight wear is normal on the worm gear surfaces.
检查齿条活塞抛光表面是否有刮痕、刻痕或磨擦。涡轮表面的轻微磨损是正常的。
8.
This dress material frays very quickly when you cut it.
这种衣料在剪裁时非常容易磨损。
9.
On the Cause of Abnormal Wear of Tyres and Protective Measures;
汽车轮胎异常磨损的原因及保护措施
10.
Exploring the Reasons for the Prevention of Abnormal Automobile Tire Wear
汽车轮胎异常磨损的原因探究及预防
11.
The Design and Experimental Study of the Friction and Abrasion Testing Machine for the Pumping Rod s Centralizer;
抽油杆扶正器摩擦磨损试验台的研制及摩擦磨损试验研究
12.
She managed to keep her sanity throughout the ordeal.
在那场磨难中她始终保持神志正常。
13.
Abrasion-resistant capability of Ni-cast iron and Cr-cast iron were studied by abrasion wears and impact test.
对镍硬铸铁和常用的铬系白口铸铁进行了削盘磨损试验和冲击磨料磨损试验。
14.
When the axial flow turbine operates in sand loaded rivers, it frequently suffers the sand wear and abrasion.
轴流式水轮机在含沙水流中运行时,常遭到泥沙磨损和磨蚀破坏。
15.
Both the derrick deviation and the wellheads eccentricity will cause the serious wearing of the casing (or casing protecting tube) close to the wellhead.
井架不正或井口偏心,会造成近井口套管(或套管防磨套)的磨损。
16.
I don't think this cheap carpet will stand up to much wear.
我认为这条廉价的地毯经不起经常的磨损。
17.
It also became clear during that stint, that the tyre degradation was very low.
也是在那个阶段,轮胎磨损显然非常的慢。
18.
A Primary Analysis on the Abnormal Wear of Sinkers on Circular Single Terry Machine
单面毛圈圆机沉降片异常磨损的初步分析