1.
Influence of Heat Treatment Hardness on the Character of Automobile Clutch Film Spring
热处理硬度对汽车离合器膜片弹簧性能的影响
2.
Effect of Heat Treatment on Hardness of 9Cr2Mo Steel
热处理工艺对9Cr2Mo钢硬度的影响
3.
Effect of heat treatment processes on microstructure and hardness of GCr18Mo steel
热处理工艺对GCr18Mo钢组织及硬度的影响
4.
Influence of Heat Treatment Temperature on Microstructure and Micro-hardness of Deposited Metal
热处理温度对熔敷金属组织及其硬度的影响
5.
Effect of Heat Treatment on Micro-Hardness of Ni-ZrO_2 Nano-Composite Electroforming Deposits
热处理对Ni-ZrO_2纳米复合电铸层显微硬度的影响
6.
Effect of heat treatment on microstructure and hardness of monel alloy containing silicon
热处理对含Si蒙乃尔合金组织及硬度的影响
7.
Hardness Decreasing Reason of Airscrew Bush Parts of Helicopter after Heat Treatment
直升机旋翼桨根衬套热处理后硬度降低的原因
8.
hardening something by heat treatment.
通过热处理使某物变硬。
9.
the obvious microhardness increase results from the formation of hardened TiC phase.
热处理后薄膜显微硬度显著升高的原因是生成了碳化钛硬化相.
10.
Production choosing β titanium alloy after heat treatment could increase the high temperature intensity and wear off with hardness of HRC42.
选择β钛合金材质生产，经热处理后增加高温强度及耐磨性，硬度HRC42。
11.
In addition, the effect of thermal treated temperature on hardness and coercive force of cobalt-boron alloy deposit was studied.
另外，研究了热处理温度对镀层硬度和矫顽力的影响。
12.
Effect of Heat Treatment Temperature on Microstructure and Hardness of High Vanadium High Speed Steel
热处理温度对高钒高速钢显微组织和硬度的影响
13.
As for welding seams of the same heat treatment state, the hardness of welding seam area depends on different welding wires.
对于同一种热处理状态的焊缝,焊缝区的硬度取决于不同的焊丝。
14.
The Influence of Heat Treatment Technology on the Impact Toughness and Hardness of White Cast Iron With Low Cr and Cu.
热处理工艺对低铬铜白口铸铁冲击韧性和硬度的影响
15.
Effect of Phosphorus Modification and Heat Treatment on Microstructure、Hardness and Wear Behavior of Mg_2Si/Al Composites
P变质及热处理对Mg_2Si/Al复合材料组织、硬度及磨损行为的影响
16.
Computer Simulation and Experimental Verification of Hardness and Microstructure Distribution of Cutting Pick After Induction Heat-treated
镐形截齿感应热处理后硬度组织分布的计算机模拟及实验验证
17.
Microstructure and Microhardness Change of Fe-Cr-C Alloy Layer Prepared by Electron Beam Scanning before and after Heat Treatment
电子束扫描制备铁-铬-碳合金层热处理前后组织与硬度的变化
18.
Effect of Heat Treatment on Hardness of Iron-based Cr-Mo-W-Mn-Ni Alloy Surfacing Layer
热处理对Cr-Mo-W-Mn-Ni铁基合金堆焊层硬度的影响