1.
The application of EDM in machining technology for more holes die
电加工在多孔冲模加工工艺中的应用
2.
Simulation study of shock wave reaction on porous material
冲击作用下多孔材料热力学特征的模拟与分析
3.
multi-aperture pulse distributor
多孔磁心脉冲分配器
4.
sidepiercing cam actuated die
侧楔作用侧向冲孔模
5.
Research on Multi-Mode Pulse Generator System for Array Holes of Micro-Jet Parts
微喷阵列孔电火花加工多模式脉冲电源系统的研究
6.
The measure of improving life of die without die plate for the hole punching on steel pipe
钢管无凹模冲孔冲头寿命提高的措施
7.
Characteristics of Gap State with Large Fluid Flow Multi-hole Flushing
大流量多孔内冲液下的放电波形特征
8.
Research and Application of Multistage Pulse Deep-Penetration Perforation Technology
多级脉冲深穿透射孔技术研究与应用
9.
The Analysis and Defense Measure of Thin Punch Destruction
冲小孔凸模破坏形式分析及预防措施
10.
Design of an Automatic Dividing Punch Mould for Spokes on Wheel Cranes
轮式起重机轮辐自动分度冲孔模设计
11.
Mechanism of Small Hole Punching on Thick Blank and Study on Die Life-span;
厚钢板小孔冲裁机理及模具失效研究
12.
Apply ANSYS in Optimizing Eyelet Clearance of Punching Die;
ANSYS在小孔冲模间隙优化中的应用
13.
Improvement of spline rod and set of piercing die forbasket type cage
筐形保持架冲孔模花键杆、套的改进
14.
Cracking Analysis of CrWMn Steel Piercing Mould
CrWMn钢冲孔模具加工过程中开裂分析
15.
Design of piercing-blanking progressive die based on Pro/E-PDX
基于Pro/E-PDX的冲孔、落料连续模设计
16.
Numerical simulation of the process of pore collapse under shock load
冲击载荷下孔隙塌缩过程的数值模拟
17.
PORESCALE SPH SIMULATION OF FLOW IN POROUS MEDIA
多孔介质中流体输运的孔尺度SPH模拟
18.
For this simulated building, the ratio of surface to volume is set to one square metre per cubic metre.
在这一模拟试验中，房间内多孔缓冲材料的表面积和房间内空间的比率为1平方米：1立方米。