1.
The Design of Fused Deposition Modeling Rapid Prototyping Machine and the Study on It's Theory;
熔融挤压堆积快速原型机的设计及理论研究
2.
Development on Methods for Determining Shearing Viscosity of Extruded Food Melt
食品挤压熔融体剪切黏度测定方法研究进展
3.
ANALYSIS OF SPRAY HEAD STRUCTURE OF FUSED DEPOSITION MODELING FOR RAPID PROTOTYPING
熔融挤压快速成型系统的喷头结构分析
4.
For extrudates there are side crushing strength tests, bulk crushing strength tests, abrasion tests.
对挤条产品有侧压强度的测试，堆积强度测试和耐磨测试。
5.
Effect of processing variables on both moisture and bulk density of extrudates in wet extrusion of fish protein
鱼肉蛋白质挤压过程中操作参数对挤出物水分含量及堆积密度的影响
6.
Preparation of Nylon 6 with High Viscosity by Chain-extension during Melting Extrusion
熔融挤出扩链反应制备高粘度尼龙6
7.
Equipment assembling technique for modern BOPET lines' chip melting and extruding system
现代BOPET生产线熔融挤出系统配置技术
8.
Solid Melting Section on the Ram Extruder Based on ANSYS
基于ANSYS的柱塞挤出机熔融段研究
9.
reduced in volume by pressure.
通过挤压而减少了体积。
10.
A gas is squeezed into a smaller volume.
气体受挤压而体积减
11.
Lava was ejected from the volcano.
熔岩受到压挤而从火山口喷射出来。
12.
The Casting, Fogging, Extrusion, Rolling & Steel
钢材的熔铸、锻造、挤压及延轧
13.
This paper introduces an analytical melting model for extrusion to calculate the melting rate and predict the meltingcapacity of screw.
根据挤出熔融模型用解析法计算熔融速率,预测螺杆的塑化能力。
14.
Melt spinning involves melting the nylon in an inert atmosphere, controlling the extrusion and solidification of the melt, and collecting the extruded filaments.
熔纺包括尼龙在惰性气体中的熔化、控制熔融体挤出和固化、卷绕挤出的长丝等几个过程。
15.
Study on the Extrusion Moulding of Ultrahigh Molecular Weight Polyethylene under Ultrasonic Irradiance;
超高分子量聚乙烯的超声熔融挤出成型研究
16.
The Theory and Visualization of Submacroscopic Melting Process in Single-Screw Extrusion;
单螺杆挤出的亚宏观熔融理论及可视化研究
17.
Research on Grafting Maleic Anhydride onto Polyolefin with Melt Extrusion
聚烯烃熔融挤出接枝马来酸酐的研究进展
18.
Study on the Melt Graft-Reacting Extrution of PE or EPDM with MAH and the Alloying of PA Toughened by the Grafts;
MAH与PE或EPDM熔融接枝反应挤出和挤出物增韧PA合金化的研究