1.
The maximum file size field contains non-numeric characters. Specify only numeric characters.
最大文件尺寸域包含非数字字符。只能指定数字字符。
2.
Measurement of Key Dimensions of Large-size and Thin-wall Pieces Based on Vision Inspection Technology;
大尺寸薄壁零件关键尺寸的视觉检测
3.
modular and dimensional co-ordination concept
构件式组合及尺寸配合
4.
Dimensional tolerances for castings
GB/T6414-1986铸件尺寸公差
5.
Raw Casting basic dimensions, in.,Over,Up to & including
毛坯铸件基本尺寸,英寸,大于,至
6.
This is a reasonable compromise based on the size of paper, file folders, briefcases, and desk drawers.
这种合理的折中，综合考虑了纸张、文件夹、公文包和抽屉的大小尺寸。
7.
An error occurred while trying to save the changes to the profile. The total size of the attributes is more than the maximum of 4096 bytes.
试图保存对配置文件的改动时出错。总尺寸超过 4096 字节。
8.
If necessary, the video file dimensions will be stretched to match the broadcast video size.
如有必要，伸展视频文件的尺寸使其与广播视频的大小相匹配。
9.
If necessary, the video file dimensions will be adjusted to match the size of the video in the broadcast.
如有必要，可调整视频文件的尺寸使其与广播中的视频大小相匹配。
10.
C sizes: Series of sizes for envelopes in the ISO range. To accommodate stationery in A series sizes.
C 度:国际标准范围内的信封尺寸系列：以容纳Ａ度系列的书信文件。
11.
Integrated power electronics module based on chip scale packaged power devices
基于芯片尺寸封装功率器件的集成电力电子模块(英文)
12.
To draw up and issue dimensional reports of supplier parts and customer certification for approval.
制作并传递外购件尺寸报告，制作客户要求的零件尺寸报告。
13.
Malleable cast iron pipe fittings--Type size--Dimensions list of pipe fittings structure
GB/T3289.1-1982可锻铸铁管路连接件型式尺寸管件结构尺寸表
14.
NOTICE: The dimensions shown on the attached dwgs for ball are the finished (after final machining) dimensions; your rough machined forging must guarantee these final dimensions.
注：附件球体图纸上的尺寸为机加工后的最终尺寸，你们的粗加工锻件必须保证这些最终尺寸。
15.
According to the size of design, the electronic file of each part and the assembly relation between all parts will be accomplished accurately.
按设计尺寸，精确地完成产品的各个零件的电子文件和零件之间的装配关系。
16.
Layout inspection is the complete measurement of all product dimensions shown on the design records.
全尺寸检验是对设计记录中有的所有零件的尺寸要全部进行测量.
17.
The size accuracy of punching workpiece mainly depends on the cutting edge sizes, tolerances of convex die and concave die.
冲裁件的尺寸精度取决于凸、模的刃口尺寸及公差。
18.
Application of laser sensor in measurement of size error for large-sized shaft parts
激光传感器在大尺寸轴类零件尺寸误差测量中的应用