1.
The perfect camber design can be obtained by introducing the center/side ratio concept of contact pressure and choosing proper ratio.
同时引入辊间接触压力的中、边部比值概念并作合理选择，使设计出的辊型更加完善。
2.
The turn roll of 600mm in diameter is mounted on the exit of turn roll room to guide strip into zinc pot.
为将带钢引入锌锅,在出口转向辊室装有一个直径为600mm的转向辊
3.
draw-off roller
牵引辊,送出罗拉,引出辊,出布辊
4.
Impression cylinder, tracting pressing roller, ink forme roller, and oven are controlled by pneumatics.
⑻压印辊筒、引压辊、墨辊、箱等开闭由气动控制。
5.
intermediate supporting bowl
中支轧辊（将辊体与辊轴的两端闷头深入辊体内相当距离，使辊体支点内移，以减少辊体的挠度）
6.
Coarse material entering the mill is crushed between the ring and rollers.
进入磨机的粗料压碎于辊和钢环之间。
7.
Investigation of the Working Principle of CMS-roller
连续混炼双辊机工作原理的深入探讨
8.
In the coating pan, baffles are used to both direct the flow of paint to the pick-up roll and direct air bubbles away from the pick-up roll.
在涂料盘中，挡板应用在引导涂料去带料辊和引导气泡从带料辊移开。
9.
To enter in an index.
入索引把…编入索引
10.
The technology of precision roll forging by closed die groove of machine driven plough share are researched systematically.
系统研究了机引犁铧闭式型槽精密辊锻技术。
11.
The Reversible Feed Roll System for Ensilage Harvester Based on MCU
基于MCU的青饲料收获机喂入辊正反转控制系统
12.
pressure roller
压紧辊，压实辊，压紧辊轮
13.
"The entry section is started again. The strip of next coil passes through welder, bridle, goes into deoiling section. "
再次启动入口段,让后继带钢通过焊机、张力辊进入脱脂段
14.
"Afterwards, the strip goes into reducing annealing furnace passing through entry looper, bridle, tension regulator. "
带钢经入口活套、张力辊、张力调节器进入还原退火炉
15.
After introduction of high-pressure roll press, the quality of pellet is improved remarkably and the smooth and stable running of grate-rotary kiln is ensured.
引进高压辊磨工艺后,球团产、量得到了改善,链箅机-回转窑运行稳定。
16.
Selection of Introduction Site for and Monitoring of Activity on the Chinese Crocodile Lizard (Shinisaurus Crocodilurus);
引入瑶山鳄蜥引入地选择及活动监测
17.
The angle of the feed into the friction rolls affects fiber alignment.
纤维喂入时与磨擦辊的夹角对纤维在纱体中的排列有一定的影响。
18.
Failure Research of the Inputting Shaft for the High Speed Wire-rod Finishing Mill in Chang Gang;
长钢高速线材精轧机夹送辊输入轴断裂失效研究