1.
gas gun for remote projection of an automatic syringe at free-roaming animals
气枪,用来向四处游荡的动物远距离发射自动注射器
2.
The standard needle length on the autoinjector is a half inch, which may not be sufficient to reach the muscle in obese adolescents.
自动注射剂标准针头长度为半英寸，这对于肥胖青少年不足以注射到肌肉内。
3.
automatic sport shoe direct injection machine
自动式运动鞋直接注射成型机
4.
automatic rotary type direct injection sport footwear making machine
自动轮转式直接注射制运动鞋机
5.
On-line determination of Mn~(2+) in water by flow injection analysis
水中锰[Ⅱ]的流动注射全自动在线分析
6.
automatic rotary type PVC sole injection moulding machine
自动旋转式PVC鞋底注射成型机
7.
full-automatic type in-line screw plastic injection mould machine
全自动螺旋直射式注塑机
8.
Design of auto-stripping injection mould with parting-out in sequence and pin gate mechanism
顺序分型点浇口自动脱料注射模设计
9.
Design of Injection Mold with Auto-Stripping Inner and Outer Screw Mechanism By Oil Cylind
油缸式自动内外螺纹脱模注射模设计
10.
Determination Trace Zinc in Seawater Using Reverse FIA Spectrophotometric Method
反相自动参比流动注射法测定海水中的微量锌
11.
Injection pedestal can be risen and fallen, convenient in mold changing and cleaning off of remained material.
注射座可自动升降，模具更换、料嘴清理极为方便。
12.
Study and Application of the Flow Injection Auto-coupled Biampeorometry Associated with Two Independent Couples;
流动注射两电对自偶合双安培法研究及其应用
13.
Combined treatment of lower limb arteriosclerosis obliterans with Chinese acupoint injection and autologous peripheral blood stem cell transplantation
穴位注射自体周血干细胞治疗下肢动脉闭塞症
14.
Injection Needle Puncture Force Tester Solution Based on Delta Automation
台达自动化注射针刺穿力测试仪解决方案
15.
Determination of Chromium(VI) by Automatic Reference Reverse Flow Colorimetry and the Application in Leather Analysis;
自动参比反向流动注射法测定Cr(VI)及在皮革分析中的应用
16.
Development and Application in the Water Analysis of Automatic Flow Injection Analyzer FIA6000+
多通道全自动流动注射分析仪在水质分析中的应用
17.
The haematomas were produced by intracutaneous injection of autologous blood on the back of the animals.
血肿是通过在动物背部皮内注射自体血液造成的。
18.
Design of Auto-Sheared Injection Mold for Edge Gate of FPD Cabinets
自动切除平板电视面框侧浇口废料的注射模设计