1.
drain valve and muzzle door interlock lever
泄水阀与前盖联锁机构柄杆
2.
Double D Stem Configuration: Gives positive attachment for handles or actuators.
双D阀杆结构:非常适用于连接操作手柄或执行机构。
3.
press safety interlock valve
压力机用安全联锁阀
4.
The regulating handle consists of manoeuvring valve pos. no.01 and handle mechanism.
调节手柄由操纵阀01和手柄机构组成。
5.
Analysis and Synthesis for Hybrid Input Five-bar Mechanism;
曲柄—连杆混合驱动五杆机构的分析与综合
6.
The valve may be padlocked in any one of the positions including opened or closed by virtue of a locking hole located in the handle and lever.
通过手柄和杠杆上的定位孔,阀门可以被锁定在开启与关闭之间的任何位置。
7.
Stem – machined stem has a backseat design.
阀杆-经过机加工的阀杆具有后座结构。
8.
Caution: If cover will not press flat against body, stem assembly is crooked and damage can result. Re-align stem and cover before bolts are inserted.
警告：如果阀盖不压平在阀体上，阀杆就可能扭曲和损坏。在插入螺栓之前，重新对齐阀杆和阀盖。
9.
Design and FEA on Crankshaft-Connecting Rod Mechanism in LJ377MV gasoline Engine;
LJ377MV汽油机曲柄连杆机构的设计与有限元分析
10.
The cap and rod have bearings which permit the crankpin to rotate freely within the rod.
轴瓦盖和连杆中有轴瓦，它允许连杆内的曲柄锁自由地转动。
11.
"Lever-lock handles are not recommended for use on 8"and larger valves."
建议不要在公称通径大于8英寸的阀门上使用杠杆固定锁手柄。
12.
Research and Development of the Forces Acting on the Crank and Connecting Rod;
曲柄连杆机构动力学分析与设计系统研究
13.
The stem and diaphragm assembly will normally remain with the cover as it is removed.
阀杆和隔膜总成通常附在阀盖上与阀盖一起拆离。
14.
Disconnect the handle-to-latch rod from the handle latch release lever arm.
从手柄-锁闩释放连杆臂上断开手柄-锁闩的连杆。
15.
The cylinder head carries the valves, valve springs and the rockers on the rocker shaft, this part of the valve gear being worked by the push-rods.
气缸盖携带阀门，气门弹簧和在摇臂杆上的摇臂，这部分的气门传动机构通过推杆工作。
16.
There is always frozen water in front of the trap forming water block to avoid steam leaking.
阀前始终有凝结水，形成水封，无蒸汽泄漏。
17.
Design and Research of Motorcycle Engine Crank-connecting Rod Mechanism Balancing Machine;
摩托车发动机曲柄连杆机构动平衡试验装置的设计与研究
18.
The assemble fictitiously and motion simulation of connecting rod in internal-combustion engine based on Pro/E
基于Pro/E的内燃机曲柄连杆机构虚拟装配与运动仿真