1.
Derivation and experiments for jet nozzles′ coefficients of self-priming irrigation pump
射流自吸喷灌泵喷嘴系数的理论推导与试验
2.
CFD Calculation of the Two-Phase Flow inside K-Factor Injection Nozzle
K系数喷油嘴喷孔内气液两相流动的三维模拟
3.
Parameter Detection System of Muzzle Based on Labview;
基于LabVIEW的喷嘴性能参数检测系统
4.
The Humidity Effect on the Discharge Coefficient of Sonic Nozzles
湿度对音速喷嘴流出系数影响的研究
5.
The Study and Design of NC Machining Spiral Groove of the Needle Valve Fuel Injector;
喷油嘴针阀螺旋槽加工数控系统研究与设计
6.
The influence of flow coefficient changes on ZH1105 diesel engine is studied in this paper.
研究了喷油嘴流量系数变化对单缸直喷柴油机性能的影响。
7.
diameter and number of hole
喷嘴量孔孔径及数目
8.
ISA 1932 nozzle
ISA 1932喷嘴
9.
Three-dimensional Numerical Simulation of Locomotive Diesel Engine Injection Nozzle;
16V280柴油机燃油系统新型喷嘴的三维流场数值模拟计算
10.
Three Dimensional Numerical Simulation on Single Atomizer Blend Flow Pressure Spray Dryer;
单喷嘴混流压力式喷雾干燥塔三维数值模拟
11.
Experimental and Numerical Investigation on Sprays of Hollow-Cone Pressure Nozzle;
空心圆锥雾化喷嘴喷雾实验与数值研究
12.
3-D Stimulation and Analysis of Weft Insertion Flow of Main Nozzle in an Air Jet Loom
喷气织机主喷嘴气流引纬三维数值模拟分析
13.
A Numerical Study on the Process of Cavitation in a Real Diesel Nozzle
柴油机喷油嘴喷孔中空泡形成过程的数值模拟
14.
Numerical Simulation of Torpedo Centrifugal Atomizer Spray Field
鱼雷离心式喷嘴喷雾场的数值模拟研究
15.
Three Dimensional Numerical Simulation of Flow Characteristic in Ultra-multi Hole Injector
超多喷孔喷油嘴流动特性的三维数值模拟
16.
The Technology of Numerical Control Reconstruction on the Injection Nozzle Center Hole and Inner Cone Grinder;
喷油嘴中孔座面磨床的数控改造技术
17.
Experimental Research and Numerical Simulation on Effervescent Atomizer;
气泡雾化喷嘴的试验研究及数值模拟
18.
Experimental study on the vortex tubes with different Mach number nozzles
喷嘴马赫数对涡流管性能影响的实验