1.
Construction Techniques of Formwork Engineering for Large-span High-brace Pre-stressed Beams;
大跨度高支撑预应力梁模板工程施工工艺
2.
Optimize the support of over-low and over-weighted beam formwork by using PDCA theory
运用PDCA理论优化超低及超重梁模板支撑
3.
Installation and inspection of concrete simply supported girder with post-tensioned prestressing
后张法预应力混凝土简支箱梁模板安装与检查
4.
The design and construction technique of some transfer story girder formwork support frame
某转换层大梁模板支撑架体设计与施工技术
5.
The Design and Calculation of The Form and Support of Superhigh and Large Span Suspended Beam
超高大跨凌空台口梁模板及支撑的设计计算
6.
Design for the Rack of 80T Three Beam Four-post Hydraulic Press
带顶模缸的三梁四柱液压机的立柱和梁板设计
7.
The simulation analysis of concrete box beam web plate stress
混凝土箱梁腹板受力状态的模拟分析
8.
Analysis of Compression Modulus of Resilience of Slab-Type Rubber Seat of Bridge
桥梁板式橡胶支座抗压弹性模量分析
9.
Abstract: A model of self-excited ae rodynamic forces acting on a sectionof bridge deck with additional surface atta ched below the trailing edge is established.
文摘:首先建立了下风侧附加翼板桥梁主梁截面的自激气动力模型。
10.
Study of Monorail Transit Emergency Beam's Bearing and Superelevation and Error Analysis of Track Beam Production Formwork
单轨交通应急梁支座与超高研究以及轨道梁生产用模板误差分析
11.
Analysis of Hydroelastic Responses of Very Large Floating Structure by Use of Sandwich Grillage Model.;
超大型浮体结构水弹性响应的梁板模型分析
12.
Research and Analyse on the Model Test of the Concrete Bridge Deck Slab of the Cable-Stayed Bridge;
斜拉桥混凝土主梁桥面板模型试验与分析
13.
Numerical Simulation Analysis of Pile-plank and Lattice Beam Structure Composite Foundation of High-speed Railway
高速铁路桩—板、格梁结构复合地基数值模拟分析
14.
Reducing and Simulating of the Stiffened Plate on Jack-up Platform in Structure Analysis
自升式平台板梁组合结构简化模拟研究
15.
Research on Stamping Forming Numerical Simulation for Side Beam Internal Plate Cover of Car
轿车侧梁内板顶盖冲压成形数值模拟研究
16.
Construction Technology of High and Large Formwork for Stadium with Extra Large Oblique Beam
体育场特大斜梁工程的高、大模板施工技术
17.
Activated Core-pulling Inner Formwork Technology for Precast Hollow Slab and Beam of Highway Bridge
公路桥预制空心板梁活络式抽芯内模技术
18.
Anti-floating Design of Needle Beam Type Formwork Lining Trolley with Full Circle Section
全圆断面针梁式模板衬砌台车抗浮设计