1.
Experimental Study on Stretch Reducing Process of Pipe and Finite Element Simulation under Crop End Control;
钢管张力减径试验研究及切头尾控制下的有限元模拟
2.
Analog control research and application of hot rolling strip head and tail shape
热连轧带钢头尾鱼尾形状模拟控制研究与应用
3.
The United States bosses the whole organization from top to bottom.
美国从头到尾控制着这整个组织。
4.
Controlled Analysis of Long Conveyor with Head and Tail Drive
长距离带式输送机头尾驱动控制技术
5.
The Improved Design and Realization for Water-stopping Control System Both in the Start and the End of Rolling the Special Stainless Steel
特殊不锈钢轧制头尾停水控制系统的改进
6.
Causes Analysis of Appearing Narrow Size of Head and End of Hot Rolled Strip and Its Control Measures
热轧带钢头尾拉窄的原因分析与控制措施
7.
Reasonable Control the Upper Crop End and Lower Crop End Weights,and Improve the Utilization Rate of Crankshaft Blank of Electroslag Remelting Ingot
合理控制切头切尾量,提高电渣钢曲轴坯成材率
8.
Analysis the causes of the hot-rolled wide strip head and tail pulling narrow and control measures
热轧宽带钢头尾拉窄的原因与控制措施
9.
Pressure Control Analysis Based on Mechanical Properties of Bolts During Grouting at Shield Tail
基于螺栓接头受力性能的盾尾注浆压力控制
10.
One of the beauties of E?marketing is that you control the entire process from start to finish.
网络营销的妙处之一，是你从头到尾地控制整个过程。
11.
Synchronous Control for Crankshaft Grinder Head-tail Stock Based on AC Servo
基于交流伺服驱动的曲轴磨床头尾架同步控制方法
12.
Arrow with an arrowhead and tail that can be adjusted using two different control handles each.
可以使用两个不同的控制手柄分别对其箭头和箭尾进行调整的箭头形状。
13.
This paper describes the processing technology of canned cow tail soup. It also presents the key processing parameters and quality requirements associated with canned cow tail soup.
该文阐述了牛尾汤罐头的工艺制作,确定了关键工艺条件及制程控制点。
14.
We remove these rear controls and install them as canard controls.
我们把尾部控制改为鸭式控制。
15.
Special gain controls are used to regulate the amplitude levels at the beginning and end of the record.
为了调节记录的开头部分和尾端的振幅电平，通常采用专门的增益控制。
16.
Analysis of Control Level of Motor Vehicle Exhaust Emission in Kunming
昆明市机动车尾气排放控制水平分析
17.
Design for the Caudal Mounting Control System of ZMS Synthetical Test Bench;
ZMS综合实验台尾架控制系统设计
18.
Transform of Controlling System of Al Tube Sealing Tail Machine of PLC
PLC铝管灌装封尾机控制系统的改造