1.
Reduced pressure near the partially closed throttle valve caused the fuel to flow from the idling jet into the intake air.
由于部分关闭的节流阀附近的压力下降,燃油由怠速喷口喷入吸进的空气。
2.
Study on Idle Speed Control Strategy for Low-displacement EFI Engine;
小排量电喷发动机怠速工况控制方法研究
3.
The Development and Research of ECU and Idle Speed Control for FAI Motorcycles;
FAI电喷摩托车ECU的研发及怠速控制的研究
4.
Influence of Operating Parameters on Exhaust Emission of EFI Gasoline Engine at Idle Speed
运转参数对电喷汽油机怠速排放的影响
5.
outlet triangle
喷嘴出口速度三角图
6.
Estimation Method of Nozzle Exit Speed for Torpedo Turbine Engine
涡轮发动机喷管出口速度的估计方法
7.
This air improves the atomization of fuel coming fron the low-speed port.
这些空气改善了从低速出口喷出的燃料的雾化。
8.
engine idling speed adjusting screw
发动机怠速调整螺丝
9.
drive idler gear
空转传动齿轮，怠速齿轮
10.
throttle positioner
节气门怠速开度控制阀
11.
squirt or spray (a liquid) quickly.
快速地喷射或喷溅液体。
12.
extra-large orifice sprinkler system
特大喷口喷水灭火系统
13.
Incorrect idle or maximum speed
怠速或最大转速均不正常
14.
Idle is rough, and high-speed miss and power loss may result.
导致怠速不稳，高速缺火和功率下降。
15.
the front moves slower than the rear and the yarn buckles. The result is that usually the warp shed must be larger than that for a shuttle loom.
纬纱前端的速度低于后部的速度,纬纱会弯曲,这就要求喷气织机的梭口应大于有梭织机的梭口。
16.
coasting richer system
强制怠速混合汽加浓装置
17.
external-type idle limiter
外装式怠速浓度调程限制器
18.
internal-type idle limiter
内装式怠速浓度调程限制器