1.
Technical requirements for jerk fuel injection pump
GB/T5770-1997柴油机柱塞式喷油泵总成技术条件
2.
Main products: oil tank, oil tube, oiler support, oil pump, oil applying wheel etc.
产品主要结构：油箱、油管、安装支架、油泵总成及涂油轮等组成。
3.
Ningbo Shiguer electric fuel pump factory and specializes in car fittings enterprises.
宁波市江东实固尔汽配厂是一家专业生产电喷汽油泵以及各种车型的油泵总成的企业。
4.
Research of the Test Bed for the Comprehensive Performance of Disc Brake's Brake Cylinder Based on PLC
基于PLC的盘式制动器制动泵总成综合性能试验台的研制
5.
guide piston complement for fuel pump
喷油泵导向活塞总成
6.
Submersible Turbine Pump Unit and Its Multi-function Valve Assembly
潜油涡轮泵机组及其多功能阀体总成
7.
The key to the technological transformation is the design of the manual oil pump、 the delivery pump and the whole transmission box.
技术改造的关键是手油泵、油泵及传动箱总成的设计。
8.
The Study and Application about Virtual Instruments Technology in TEE Function Measurement;
虚拟仪器技术在油泵支架总成功能测试中的研究与应用
9.
MASTER CYLINDER/BRAKE BOOSTER ASSEMBLY
总泵/煞车倍力器组装
10.
"The pump casing shall be suitably ribbed, have tangential discharge, and be reinforced to support the weight of the motor assembly."
泵壳应该有适当的肋骨,按切线方向排放,能够再加固以支撑电机总成的重量。
11.
Install brake lines that connect master cylinder to combination valve.
安装连接总泵至组合阀的煞车管线。
12.
Master cylinder bushing at the clutch pedal.
离合器踏板处的总泵衬套。
13.
Summary on the remoulding of mechanical seals of pumps for conveyance of vinyl chloride monomer
氯乙烯单体输送泵机械密封改造总结
14.
Pumps in which displacement is accomplished mechanically are called positive displacement pumps.
用机械方法完成位移的泵称为正位移泵。
15.
diffuser assembly
扩压器总成扩散器总成
16.
An overview of working procedure for loading/ unloading pump is given in this document.
此文给出了对装卸泵工作方式的总体说明。
17.
Experimental and Theoretical Investigations of Gas Engine-Driven Heat Pump Cogeneration System;
燃气机热泵总能系统的理论分析与试验研究
18.
Intelligent Monitoring System for Temperature and Coolant Level of Slurry Pump Based on CAN Fieldbus Thchnology;
基于CAN总线的智能渣浆泵轴温及液位监控系统