1.
Remove the relief valve cover bolts while holding the cover down.
边压住阀盖，边拆卸安全阀阀盖螺栓。
2.
Stainless steel stuffing box hardware is standard (ie. bolts, gland studs, nuts, washers).
标准的金属密封不锈钢填料箱（如螺栓、填料压盖螺栓、螺母、垫圈）。
3.
Analysis on Fatigue Cracking of Cylinder Cap Bolt
缸盖螺栓接触损伤引发疲劳开裂分析
4.
Equally distributed gland bolts provide uniform compression of packing.
均匀分布的压盖螺栓为填料提供均匀的压力。
5.
The Fuzzy Reliability Design about the Bolt-joint Set of Engine Bonnet
内燃机缸盖螺栓组联接的模糊可靠性设计
6.
Cause of Excessive Temperature of Cover Bolt of Russia-made TBB-500-2EY3 Generator
俄制TBB-500-2EY3型发电机端盖螺栓温度高原因分析
7.
Effect of Bolt Hole Depth on Camshaft Bore of YZ4DE Diesel Engine
YZ4DE柴油机气缸盖螺栓沉孔深度对凸轮轴孔的影响
8.
cap-and-pin type insulator
帽盖穿心螺栓式绝缘子
9.
Install the bolts attaching the end cap to the front fender.
安装连接末端端盖到前挡泥板的螺栓。
10.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
11.
The valve cover shall be held in place through the use of a single grooved style two-bolt coupling.
阀盖应该通过单个沟槽状双螺栓联结器固定住。
12.
Bolted on, top entry single access cover for ease of maintenance.
螺栓固定，顶部进入的唯一检修盖，便以维护。
13.
Sweat Solder adapter with Cover Tube and Cast Set Screw Wall Flange
焊接焊料适配器含盖管和铸造固定螺栓墙法兰
14.
The cylinder head is attached to the block with high-tensile steel studs.
气缸盖与气缸体用高强度的钢螺栓缚连结。
15.
Using a wrench, place the bolts back into the cover and tighten.
用扳手将螺栓放回到阀盖上，并加以紧固。
16.
Optimal Design of the Main Bolt of Top Cover of the Ammonia Converter Based on ANSYS
基于ANSYS对氨合成塔端盖主螺栓的优化设计
17.
Breaking Reason and Solution of the Connecting Bolts Used in the Ball Mill End Cover
球磨机端盖法兰连接螺栓的断裂原因及其解决
18.
MATERIAL AND SERVICE– Cast steel bolted bonnet valves are available in a variety of body/ bonnet materials and trims.
材料和应用–铸钢螺栓阀盖阀门可配置多种阀体/盖材料和阀内件。