1.
Modeling and Simulation for Hydraulic System of Aircraft Landing Gear Taxiing Test-Bed Based on EASY5
基于EASY5的飞机起落架滑跑试验台液压系统建模与仿真
2.
Analysis of Aircraft Taxiing-induced Response with Multiple Wheels and Multiple Landing Gears;
多轮多支柱起落架飞机滑跑响应分析
3.
The Hydraulic System Design of Test Table for Some Aircraft Alighting Gear Actuating Cylinder;
某型飞机起落架收放作动筒试验台液压系统的设计
4.
On project for transducer of running attrition test bench to single-rail bogie;
浅谈单轨转向架跑合试验台变频器方案设计
5.
Utilization of CAN Fieldbus Technique in Electro-hydraulic Loading Trial for the Landing Gear
CAN总线在起落架电液加载试验中的应用
6.
Design and Realization of Electro-hydraulic Load Trial System of Landing Gear Based on CAN bus
基于CAN总线起落架加载试验系统的设计与实现
7.
Then the horizontal load to aeroplane undercarriage tyre can be obtained more accurately by making use of the proposed model and results of drop-test simultaneously.
根据起落架落震试验结果和该数学模型，可以得到考虑动态效应的起落架机轮水准载荷。
8.
Request a low flying over the runway for gear check.
请求低空飞行通过跑道检查起落架。
9.
The Research on the Modeling & Simulation and the Test Rig for Vehicle with VLSD;
车用粘性式限滑差速器建模仿真与台架试验研究
10.
bench adjustment
机架调整，试验台上调整
11.
dynamometer engine test bed
发动机测功器试验台架
12.
Design on Support Automatic in/out System of Hydraulic Powered Support Test Rig
液压支架试验台自动进出架系统设计
13.
The landing gear struts on the Synergy N9 feature an internal skid capturing system.
起落架的撑杆协同N9号专题捕捉系统内部打滑.
14.
raise/lower the undercarriage
收起[放下]起落架.
15.
Design of Integrative Test Table for Accessories of Airplane Anti-brake
飞机防滑刹车附件综合试验台的设计
16.
In a ski jumping event, the skier takes off from a ramp and lands on the water.
跳跃滑水项目中，运动员在滑台上起跳并落入水中。
17.
A parametric modeling of parts of undercarriage parts using API in CATIA
以CATIA为平台的起落架零件参数化建模技术研究
18.
Design of the Software of the Master Console in Loading Trial System of Landing Gear Based on LabWindows/CVI
基于LabWindows/CVI的起落架电液加载台总控软件设计