1.
Research on Electrostatic Spark Sensitivity of RDX-Al in the Process of Roller Mixing
RDX与Al混合体系的静电火花感度研究
2.
Hydrogen is easily ignited by heat, open flames, electrical sparks, and static electricity.
热、明火、电火花和静电很容易点燃氢。
3.
Investigation of the igniting capability of ESD sparks
典型静电放电火花点燃能力测试研究
4.
taper wire-cut EDM machine
锥度电火花线切割机床
5.
Large static charges may build up in the bed causing spark discharges.
大量静电荷可能在床内积聚而引起火花放电。
6.
Care should be taken to eliminate sources of ignition such as sparks from electrical equipment, static electricity sparks, open flames, or any extremely hot objects.
必须特别小心地清除火源，如电力设备的火花、静电火花、明火或任何很热的物体。
7.
electric ignition
电火花点火,电气点火
8.
Machining Technology and Processing Art of Integrated Hydrostatic Bearings Using EDM
整体静压轴承电火花加工技术与工艺研究
9.
AC induction motor will govern speed stepless, no brush、 no spark and long life.
交流感应电机无极调速，无电刷、火花、寿命。
10.
AC induction motor will govern speed stepless, no brush、no spark and long life.
交流感应电机无极调速，无电刷、无火花、长寿命。
11.
Accuracy of electrical discharge machine
GB/T5291-1985电火花成型机床精度
12.
Calculation and analysis for temperature field of powder-mixed fluid EDM
混粉电火花加工温度场的计算与分析
13.
The Optimized Research of Technics on Super-large Thickness Machining Technology of WEDM
超大厚度电火花线切割工艺优化研究
14.
Detection of Electronic Contact Spark and Its Remote Sensing Alarm
电路中触点火花的检测及遥感报警系统的研制
15.
EDM (Electric Discharge Machine)
电火花(模具工业)
16.
The problem can be hazardous in the operating room of a hospital, where a static electric spark may ignite combustible or explosive vapors.
在医院的手术室静电会导致严重事故,在这里静电火花会点燃易燃易爆气体。
17.
A capacitor is used to eliminate sparking when a circuit containing inductance is suddenly opened.
当含有电感的电路突然断开时，电容器可用以消除火花。
18.
THE STUDY OF RAISING RACE OF WIRE CUT EDM OF MAGNETIC STEEL
提高磁钢电火花线切割加工速度的实验研究