1.
Influence of voltage regulating and control mode for power type load on voltage stability of load side
功率型负荷的调压控制方式对负荷端电压稳定的影响
2.
Automatic compensation load reactive power, enhancing the load power factor.
自动补偿负荷无功功率，提高负荷功率因数。
3.
Load Factor The load factor is the ratio of the average load to the generator set power rating.
负荷系数负荷系数指的是机组的平均负荷与额定功率之间的比率。
4.
Research on Relationship Between Load and Power in Anaerobic Power Step Test;
台阶无氧功率实验中负荷与功率关系的研究
5.
Analysis of Temperature Field for the Piston of 6DE1 Diesel Engine;
6DE1大功率柴油机活塞热负荷分析研究
6.
Changes of EEG Power Before and After Barbell Squatting Rising with Load;
杠铃蹲起负荷前、后脑电功率值的变化
7.
Research on the Reactive Power of Non-linear Load and Its Measuring Method;
非线性负荷的无功功率及其检测方法研究
8.
A Hybrid Reactive Power Compensation Scheme under Imbalance Load
一种不对称负荷的无功功率混合补偿方式
9.
A load shedding method based on the power vacancy sensitivity analysis
基于功率缺额灵敏度分析的切负荷算法
10.
Analysis and Affect Measures for Reactive and Harmonics in Atypical Power Load (Cycloconverter Drive Load)
非典型电力负荷(交-交变频器驱动负荷)的无功和谐波及对策
11.
Study on the Electric Load Shift Rate of the Novel Energy Storage Air-conditioning System;
新型蓄能空调系统全年电力负荷转移率研究
12.
Probability Model for Driver Attention State under High Driving Load
高负荷驾驶任务下驾驶员注意力状态概率模型
13.
Evaluation Method of Load-following Benefit for Pumped-storage Station Based on the Probability Model of Load-increasing
基于概率升荷模型的抽水蓄能电站负荷跟踪效益评估
14.
Select the load power type from the drop-down list.
从下拉列表中选择负载功率类型。
15.
The governor must have provision for adjusting speed (generator frequency) and speed droop (no load to full load).
调速器必须具备转速调整（发电机频率）和降速降调整（零负荷到满负荷）功能。
16.
Surface electromyography signal power spectrum during static load using two-dimensional mapping analysis
静态负荷表面肌电信号功率谱的二维地形图分析
17.
The requirement to the partial load running of large fans and pumps becomes higher and higher.
对非满负荷运行大功率风机和水泵的要求则越来越高
18.
The response rate speed governor to the given power signal directly affects the load regulating process of generatorset.
调速器对功率给定信号响应速度，直接影响著机组负荷的调整过程。