1.
Molding Process Analysis and Injection Mold Design for the Automobile Door Plate
汽车门板零件工艺分析和注射模设计
2.
Remove the trim panel from the front door.
从前车门上拆卸饰板。
3.
take one's foot off the throttle
脚离开（汽车的）油门踏板.
4.
Remove the door module from the trim panel.
从饰板上拆卸车门模组。
5.
Take one's foot off the throttle, ie off the accelerator, in a car
脚离开（汽车的）油门踏板
6.
"Such as the hood, the fenders, the roof panels, the door, the instrument panel, the Bumpers and the luggage compartment. "
例如,发动机盖板,挡泥板,车身顶板,车门,仪表板,汽车保险杠和行李箱。
7.
.(formerly)foot-board under the doors of a car
（旧时）汽车车门下方的踏板.
8.
Remove the door trim panel as described in Door Module (front door) or Power Window Switch (rear door) in this group.
按本单元的“车门模组”（前车门）或“电动窗开关”（后车门）中所描述的方法拆除车门饰板。
9.
Install door waterdam and trim panel.
安装车门挡水器和装饰板。
10.
Front Door Flag Trim Panel Remove/Install
前车门标记装饰板的拆卸/安装
11.
The rear door scuff plate is attached with molded-in snap retainers.
后车门框板由模制紧压保持器连接。
12.
Remove the panel/demist door vacuum actuator from the vehicle.
从车辆拆卸仪表板/除霜门真空引动器。
13.
A Study on Intelligent Control of Motor driven Door Lock of Cars
轿车电动卡板式门锁的智能控制研究
14.
The Cracking Analysis and Research for Back Door of Passenger Vehicle;
轻型客车背门外板开裂问题分析研究
15.
Analysis and Improvement of Press Process of Train Panel Header
火车门头板模具冲压工艺分析及改进
16.
Analysis and optimization of drawing process for interior car door panel
汽车门内板拉深成形工艺分析与优化
17.
Research and development on 5754 aluminum alloy plate used on the door of sedan
轿车门内用5754铝合金板材的研发
18.
Position scuff plate on sill and snap into place.
将车门框板放置在门槛上并且压紧到位。