1.
Analysis of Large Diameter Gas Drainage Well Casing Collapsing Strength Computation
大口径瓦斯排放井套管抗挤强度计算分析
2.
Intensity Analysis and Calculation of the Principle Shaft System Parts of Continuous Extrusion Machine;
连续挤压机主轴部件强度分析与计算
3.
The flat container is important tool for extruding large-sized aluminum wallboard. The kinds of flat containers, the design method and strength computing were introduced.
扁挤压筒是挤压大型铝壁板的重要工具。介绍了扁挤压筒类型、计方法和强度计算。
4.
Finite element ANSYS analysis method of bending casing collapsing strength
弯曲套管抗挤强度有限元ANSYS分析方法
5.
Influence by Oil Casing Imperfections on Anti-Collapse Strength
石油套管几何缺陷对抗挤强度的影响
6.
Study on Lateral Bearing Capacity and Lateral Stiffness of Prestressed Brick Walls;
集中式预应力砖墙的抗侧强度及抗侧刚度计算方法的研究
7.
Pulverized-coal Ash Concrete Nonlinear Compressive Strength Computation Model
粉煤灰混凝土抗压强度非线性计算模型
8.
Excel-based Calculation Program for Compressive Strength of Concrete Detected by Rebound Method
基于Excel的回弹法检测混凝土抗压强度计算程序
9.
CROSS SECTION STRENGTH CALCULATION OF PARTIAL BONDED PRESTRESSED CONCRETE BEAM ON DYNAMIC LOADING
抗动载部分预应力混凝土梁正截面强度计算
10.
Research on Collapse Strength of Oil Casing under Non-uniform Loads
非均布载荷下石油套管抗挤强度问题研究
11.
Finite element analysis on the comprehensive factors of slotted liner collapsing strength
割缝筛管抗挤压强度综合因素有限元分析
12.
Residual Collapsing Strength Analysis of Bending Part Casing in Medium/Short Radius Horizontal Wells
中短半径水平井弯曲段套管剩余抗挤强度分析
13.
Collapsing Strength Analysis of Extra-heavy Wall Casing Under Nonuniform Loads
特厚壁套管在非均载荷下的抗挤强度分析
14.
The Best Calculation of Technological Gradient for Plastic Mould Cavity by Cold-Pressing;
塑料模冷挤型腔最佳工艺斜度的计算
15.
Mathematical model of design and calculation of aluminum profile extrusion die land length
型材挤压模工作带长度设计计算的数学建模
16.
Research on the Formula of Aseismatic Shear Strength in Aerated Concrete Block Wall
加气混凝土砌块墙抗震剪切强度计算公式的研究
17.
Water and Earth Pressures Acting on Retaining Structure and How to Choose the Shear Strength Parameters;
基坑支护中水土压力的计算及抗剪强度指标的选取
18.
Design optimization for warm forming process of engine shell of high strength steel
高强度钢发动机壳体温挤压成形工艺优化设计